Granular pressure and particle velocity fluctuations prediction in liquid fluidized beds

被引:35
|
作者
Gevrin, F. [1 ]
Masbernat, O. [1 ]
Simonin, O. [2 ]
机构
[1] CNRS INP UPS, UMR 5503, Lab Genie Chim, F-31106 Toulouse, France
[2] CNRS INP UPS, Inst Mec Fluides, UMR 5502, F-31400 Toulouse, France
关键词
granular pressure; velocity fluctuations; solid fraction; liquid fluidization; kinetic theory;
D O I
10.1016/j.ces.2008.01.031
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
A numerical modelling approach for the dynamic simulation of solid-liquid fluidized beds is evaluated. This approach is based on an Eulerian two-fluid formulation of the transport equations for mass, momentum and fluctuating kinetic energy. The solid-phase fluctuating motion model is derived in the frame of granular medium kinetic theory accounting for the viscous drag influence of the interstitial liquid phase. Solid-liquid fluidized bed two-dimensional simulations were performed for flow configurations taken from the experimental work of Zenit et al. [1997. Collisional particle pressure measurements in solid-liquid flows. Journal of Fluid Mechanics 353, 261-283], for three types of solid particles of contrasted inertia in water at high particle Reynolds number (nylon, glass and steel beads). Experimental and numerical granular pressures exhibit a satisfactory agreement with both low and high inertia particles, the best level of prediction being observed with the most inertial particles. Sensitivity of the predictions to the phenomenological laws used in the model is also presented and it appears that, due to non-linear correlations, the average granular pressure in the bed is a less sensitive variable than the fluctuating kinetic energy (or granular temperature). The transport mechanisms of the mean granular temperature in the bed are therefore analyzed as a function of the solid fraction and the particle inertia. At low and moderate Stokes number (nylon and glass beads) and in all range of solid-phase fraction, the dominant production mechanism of fluctuating kinetic energy is due to the mean velocity gradient, whereas the main dissipation term is that induced by the viscous drag. At higher Stokes number (steel beads) and concentration, the production of the granular temperature is controlled by the compressibility effects via the granular pressure. In this case, the dissipation is mainly provided by inter-particle collisions. (c) 2008 Elsevier Ltd. All rights reserved.
引用
收藏
页码:2450 / 2464
页数:15
相关论文
共 50 条
  • [41] The effect of column tilt on flow homogeneity and particle agitation in a liquid fluidized bed
    Aguilar-Corona, A.
    Masbernat, O.
    Figueroa, B.
    Zenit, R.
    INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 2017, 92 : 50 - 60
  • [42] Minimum fluidization velocities and maximum bed pressure drops for gas-solid tapered fluidized beds
    Sau, D. C.
    Mohanty, S.
    Biswal, K. C.
    CHEMICAL ENGINEERING JOURNAL, 2007, 132 (1-3) : 151 - 157
  • [43] Property-averaging applied to determination of volume contraction in binary-solid liquid-fluidized beds
    Escudie, Renaud
    Epstein, Norman
    CANADIAN JOURNAL OF CHEMICAL ENGINEERING, 2008, 86 (03): : 261 - 266
  • [44] A Stokes number-dependent filtered drag model for fluidized gas-particle beds with varying material properties
    Zhao, Yiming
    Yuan, Shouzheng
    Chen, Xiao
    Zhou, Qiang
    POWDER TECHNOLOGY, 2025, 457
  • [45] Investigation of segregation of large particles in a pressurized fluidized bed with a high velocity gas: A discrete particle simulation
    Shoushtari, Navid Alavi
    Hosseini, Seyyed Abolhassan
    Soleimani, Reza
    POWDER TECHNOLOGY, 2013, 246 : 398 - 412
  • [46] A Mixture Model With Slip Velocity for Saturated Granular-Liquid Free-Surface Flows
    Tang, Jinbo
    Lin, Pengzhi
    Cui, Peng
    WATER RESOURCES RESEARCH, 2024, 60 (04)
  • [47] 3D particle-scale modeling of gas-solids flow and heat transfer in fluidized beds with an immersed tube
    Wahyudi, Hadi
    Chu, Kaiwei
    Yu, Aibing
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 97 : 521 - 537
  • [48] Modified MFIX code to simulate hydrodynamics of gas-solids bubbling fluidized beds: A model of coupled kinetic theory of granular flow and discrete element method
    Zhang, Qinghong
    Cai, Wenjian
    Lu, Cailei
    Gidaspow, Dimitri
    Lu, Huilin
    POWDER TECHNOLOGY, 2019, 357 : 417 - 427
  • [49] Granular Segregation in Gravity-Driven, Dense, Steady, Fluid-Particle Flows over Erodible Beds and Rigid, Bumpy Bases
    Jenkins, James T.
    Larcher, Michele
    WATER, 2023, 15 (14)
  • [50] Direct numerical simulation of gas-solid suspensions at moderate Reynolds number: Quantifying the coupling between hydrodynamic forces and particle velocity fluctuations
    Tenneti, S.
    Garg, R.
    Hrenya, C. M.
    Fox, R. O.
    Subramaniam, S.
    POWDER TECHNOLOGY, 2010, 203 (01) : 57 - 69