Mechanical strength and flexural parameters analysis of micro-steel, polyvinyl and basalt fibre reinforced magnesium phosphate cement mortars

被引:57
|
作者
Haque, M. Aminul [1 ,2 ]
Chen, Bing [1 ,2 ]
Ahmad, Muhammad Riaz [1 ]
Shah, Syed Farasat Ali [1 ]
机构
[1] Shanghai Jiao Tong Univ, State Key Lab Ocean Engn, Shanghai 200240, Peoples R China
[2] Shanghai Jiao Tong Univ, Dept Civil Engn, Shanghai 200240, Peoples R China
基金
中国国家自然科学基金;
关键词
Mechanical properties; Correlation equations; Flexural ductility performance; Energy absorption; Modulus of elasticity; PVA FIBER; BEHAVIOR; PERFORMANCE; CONCRETE; FRACTURE; BOND;
D O I
10.1016/j.conbuildmat.2019.117447
中图分类号
TU [建筑科学];
学科分类号
0813 ;
摘要
Magnesium phosphate cement composites exhibits higher compressive strength with high brittleness in nature that minimizes the scope of this material for flexural ductility performance. The study targeted to enhance the flexural qualities along with compressive strength of MPC compound through adding the three different fibres such as micro-steel fibre, polyvinyl alcohol fibre and basalt fibre. Inclusion of each fibre was followed a consecutive dosages system such as 0.6%, 0.8%, 1% and 1.2% of the gross mass of binders and aggregate. The compressive strength, three point flexural strength, four point flexural strength and splitting tensile strength tests were considered to explore the flexural characteristics and modulus of elasticity of the prepared fibre reinforced magnesium phosphate cement mortars with the passage of age. The experimental results pointed out the improvement about 20% to 43%, 15% to 25% and 50-72% in the TPFS, FPFS and STS than control specimens at 28d, whereas only around 5% to 10% progresses were noticed in CS for the inclusion of fibres from 0.6% to 1% in FRMPC combinations. In addition, the outcomes of flexural parameters analysis from load-displacement curves exposed the well development for mixing of 0.8-1% MSF and 0.8% PVAF and BF in the representative MPC compositions that displayed the deflection hardening and deflection softening behavior suitably. Moreover, the L-D curves of TPFS showed the advanced MOE because of less stress distribution intensity in whole cubical samples with low deformations in comparison to other two flexural tests. The study also suggested some power equation based empirical expressions for predicting the strength properties at early ages and correlation equations for flexural tests including MOE in relation to CS results. The analytical findings and recommended correlation equations might be applied in the practical applications of FRMPC related aspects. (C) 2019 Elsevier Ltd. All rights reserved.
引用
收藏
页数:14
相关论文
共 26 条
  • [21] Mechanical properties analysis of flexural member in high strength steel reinforced concrete
    Li, Hao
    Hao, Jiping
    Jiang, Weishan
    Wang, Xiantie
    Jianzhu Jiegou Xuebao/Journal of Building Structures, 2006, 27 (SUPPL.): : 495 - 498
  • [22] Mechanical Properties of Steel Fiber Reinforced Magnesium Phosphate Cement-Based Composite by Slurry Infiltrating
    Li Z.
    Qin J.
    You C.
    Yue Y.
    Jia X.
    Qian J.
    Kuei Suan Jen Hsueh Pao/Journal of the Chinese Ceramic Society, 2019, 47 (11): : 1559 - 1565
  • [23] Material Analysis of Steel Fibre Reinforced High-Strength Concrete in Terms of Flexural Behaviour. Experimental and Numerical Investigation
    Bywalski, Czeslaw
    Kazmierowski, Maciej
    Kaminski, Mieczyslaw
    Drzazga, Michal
    MATERIALS, 2020, 13 (07)
  • [24] Powder-bed 3D printing by selective activation of magnesium phosphate cement: Determining significant processing parameters and their effect on mechanical strength
    Salari, Farid
    Zocca, Andrea
    Bosetti, Paolo
    Hlavacek, Petr
    Italiano, Antonino
    Gobbin, Filippo
    Colombo, Paolo
    Kuhne, Hans-Carsten
    Sglavo, Vincenzo M.
    OPEN CERAMICS, 2024, 18
  • [25] In-situ strength effects in long fibre reinforced composites: A micro-mechanical analysis using the phase field approach of fracture
    Guillen-Hernandez, T.
    Quintana-Corominas, A.
    Garcia, I. G.
    Reinoso, J.
    Paggi, M.
    Turon, A.
    THEORETICAL AND APPLIED FRACTURE MECHANICS, 2020, 108 (108)
  • [26] Analysis of parameters influencing mechanical behavior of embedded circular steel tube confined reinforced high-strength concrete composite columns
    Ke, Xiaojun
    Chen, Zongping
    Xue, Jianyang
    Su, Yisheng
    Jianzhu Jiegou Xuebao/Journal of Building Structures, 2014, 35 : 113 - 119