Design of a novel low-frequency square-wave digital electronic ballast for HID lamps
被引:1
作者:
Zuo, Zhuang
论文数: 0引用数: 0
h-index: 0
机构:
Harbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R ChinaHarbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R China
Zuo, Zhuang
[1
]
Xu, Dianguo
论文数: 0引用数: 0
h-index: 0
机构:
Harbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R ChinaHarbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R China
Xu, Dianguo
[1
]
Zhang, Xiangjun
论文数: 0引用数: 0
h-index: 0
机构:
Harbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R ChinaHarbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R China
Zhang, Xiangjun
[1
]
Liu, Hankui
论文数: 0引用数: 0
h-index: 0
机构:
Harbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R ChinaHarbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R China
Liu, Hankui
[1
]
机构:
[1] Harbin Inst Technol, Dept Elect Engn, Harbin 150001, Peoples R China
来源:
2007 IEEE POWER ELECTRONICS SPECIALISTS CONFERENCE, VOLS 1-6
|
2007年
关键词:
DBI;
HID lamps;
ZVS;
digital ballast;
D O I:
10.1109/PESC.2007.4342523
中图分类号:
T [工业技术];
学科分类号:
08 ;
摘要:
This paper presents a low-cost low-frequency square-wave digital electronic ballast for high density discharge (HID) lamps. A highly efficient and reliable topology-dual buck half-bridge inverter (DBI) is adopted to supply the lamp with low-frequency square-wave positive and negative current avoiding acoustic resonances. The constant bus voltage is provided by the front end PFC stage. The DBI is controlled to operate under ZVS condition and the problem of excessive inductor current during low-frequency reversal transient is solved by single cycle control. The AVR special microcontroller for HID ballast is used to raise control performance and simplify the control circuit. The presented circuit was verified with experimental results. A prototype of 70W digital HID ballast has been built with the whole efficiency of 93%.