Demonstration of a solar combi-system utilizing stable supercooling of sodium acetate trihydrate for heat storage

被引:26
作者
Englmair, Gerald [1 ,2 ]
Kong, Weiqiang [1 ]
Berg, Jakob Brinko [1 ]
Furbo, Simon [1 ]
Fan, Jianhua [1 ]
机构
[1] Tech Univ Denmark, Dept Civil Engn, Brovej 118, DK-2800 Lyngby, Denmark
[2] Univ Chinese Acad Sci, Sino Danish Ctr, 380 Huaibeizhuang, Beijing, Peoples R China
关键词
Solar heating system; System demonstration; Control strategy; Heat storage prototype; Phase change material; Stable supercooling; THERMAL-ENERGY STORAGE; PHASE-CHANGE MATERIALS; HOT-WATER TANK; ACTIVE-HOUSES; DRUM REACTOR; IMPROVEMENT; COMPOSITES; SOLIDIFICATION; SIMULATIONS; UNITS;
D O I
10.1016/j.applthermaleng.2019.114647
中图分类号
O414.1 [热力学];
学科分类号
摘要
Achieving a high fraction of solar heat in heat supply for domestic buildings would reduce the use of fossil fuels for heat generation and has been a goal for a long time. Combined short and long-term heat storage has been identified as one way of achieving solar fractions higher than 50 percent in heat supply for domestic buildings. To this end, a laboratory solar heating system was built with heat-pipe tubular collectors 22.4 m(2) in aperture and a heat-storage prototype consisting of a 735 L water tank and four PCM units each containing 200 kg sodium acetate trihydrate (SAT) composite. The SAT composite was utilized as sensible heat storage with the additional ability to release heat of fusion on demand. Operation was demonstrated with the space heating and hot water demand patterns of a standard-size Passive House in the Danish climate. A strategy was developed to control the system. Seven operation modes enabled combined charging of water tank and PCM units, heat transfer from PCM units to the water tank when heat was in demand, and the right timing of auxiliary heating. We present the controller settings identified and the heat transfer fluid flow rates applied. Sequences of water tank charging, and single and parallel PCM unit charging were used to match the collector power available and the heat transfer limitations of the stores. During the charging of PCM units, the flow temperature was kept between 70 and 95 degrees C to allow continuous heat transfer rates of up to 16 kW. Peaks of up to 36 kW occurred when PCM units were added to the charging circuit. During heat transfer from PCM units to the water tank, flow temperatures were close to the SAT composite temperature and thermal power of up to 6 kW was measured. The heat stores were efficiently utilized in spring and autumn. The developed control strategy and measurement data from system demonstration will form the basis for numerical performance investigations.
引用
收藏
页数:12
相关论文
共 45 条
  • [41] Tetraethylammonium chloride as a novel eutectic partner for sodium acetate trihydrate-tailored phase change materials for efficient solar heat pump systems
    Yuan, Yingzheng
    Man, Xi
    Lu, Hao
    Ling, Ziye
    SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2025, 285
  • [42] Thermal property and latent heat energy storage behavior of sodium acetate trihydrate composites containing expanded graphite and carboxymethyl cellulose for phase change materials
    Shin, Hye Kyoung
    Park, Mira
    Kim, Hak-Yong
    Park, Soo-Jin
    APPLIED THERMAL ENGINEERING, 2015, 75 : 978 - 983
  • [43] Performance of a demonstration solar PVT assisted heat pump system with cold buffer storage and domestic hot water storage tanks
    Dannemand, Mark
    Perers, Bengt
    Furbo, Simon
    ENERGY AND BUILDINGS, 2019, 188 : 46 - 57
  • [44] Preparation of a novel sodium acetate trihydrate-based composite phase change material and thermal performance of its integration in a coil-type thermal energy storage unit for heat pump system
    Li, Biao
    Ren, Bo
    Tian, Jiaming
    Yu, Junjie
    Wang, Bowei
    Wang, Yueshe
    JOURNAL OF ENERGY STORAGE, 2024, 88
  • [45] Thermal conductivity enhancement of a sodium acetate trihydrate-potassium chloride-urea/expanded graphite composite phase-change material for latent heat thermal energy storage
    Jin, Xin
    Xiao, Qiuke
    Xu, Tao
    Huang, Gongsheng
    Wu, Huijun
    Wang, Dengjia
    Liu, Yanfeng
    Zhang, Hongguo
    Lai, Alvin C. K.
    ENERGY AND BUILDINGS, 2021, 231