The development of a novel, microwave assisted, half-warm mixed asphalt

被引:16
作者
Dulaimi, Anmar [1 ,2 ,3 ]
Al-Busaltan, Shakir [4 ]
Sadique, Monower [3 ]
机构
[1] Univ Warith Al Anbiyaa, Coll Engn, Karbala, Iraq
[2] Minist Educ, Karbala, Iraq
[3] Liverpool John Moores Univ, Sch Civil Engn & Built Environm, Liverpool, Merseyside, England
[4] Univ Kerbala, Coll Engn, Dept Civil Engn, Karbala, Iraq
关键词
Cold mix asphalt; Half-warm mix asphalt; Microwave heating; Stiffness modulus; Sustainability; Waste fillers; Wheel track test; MECHANICAL-PROPERTIES; EMULSION MIXTURES; COLD; CONCRETE; HYDRATION; CEMENT; MICROSTRUCTURE; TEMPERATURE; BEHAVIOR; PAVEMENT;
D O I
10.1016/j.conbuildmat.2021.124043
中图分类号
TU [建筑科学];
学科分类号
0813 ;
摘要
Global warming is an imminent threat that the world and its inhabitants have to confront. As such, it is the duty of the pavement industry as a contributor of greenhouse gas emissions, to pave the way by lowering its carbon footprint. It is vital that new measures are adopted in order to do so such as employing the use of emulsion-based mixtures (EBM). The problem with this is that the performance properties of such mixtures are inferior to that of traditional hot mix asphalts (HMAs). The air void content of EBM is very high and considered unacceptable by road engineers for application as a surface layer. That said, these mixtures are not only environmentally friendly but also boast ecological and economic advantages. An innovate approach was applied in this research by using a pre-compaction microwave processing technique to develop a novel, half-warm mix asphalt mixture (H-WM). This new mix was shown to have improved mechanical properties and lower air void content. EBM mixtures comprised of cementitious binary blended filler, were prepared using microwave heating applied over different lengths of time. Stiffness modulus, air voids content and temperature were used to establish the optimum microwave radiation time. The results indicated that 1.5 min of microwave processing decreased air void content from 8.92% to 7.12%. A 7% improvement in stiffness modulus was also found and the temperature was within lower limits (43 degrees C). Hydration was accelerated by the microwave radiation, and the demulsification of bitumen emulsion was promoted. Microwave processing was found to have a positive impact on permanent deformation at elevated temperatures in comparison to the two reference HMAs used. It also proved to be an adequate technique to produce a fast-curing H-WM with lower air voids content. Water damage resistance for the microwaved H-WM (99%) is better than the reference HMA mixes. The findings of this study show that the novel half-warm asphalt mixture has superior properties in comparison to EBM. (c) 2021 Elsevier Ltd. All rights reserved.
引用
收藏
页数:12
相关论文
共 104 条
[91]  
Toraldo E, 2014, SUSTAINABILITY, ECO-EFFICIENCY AND CONSERVATION IN TRANSPORTATION INFRASTRUCTURE ASSET MANAGEMENT, P53
[92]   Highway trial sections: Performance evaluation of warm mix asphalt and recycled warm mix asphalt [J].
Valdes-Vidal, G. ;
Calabi-Floody, A. ;
Sanchez-Alonso, E. ;
Diaz, C. ;
Fonseca, C. .
CONSTRUCTION AND BUILDING MATERIALS, 2020, 262
[93]  
Van de Ven M.F.C., 2007, International Journal of Pavement Engineering, V8, 2, P163
[94]   Review of warm mix rubberized asphalt concrete: Towards a sustainable paving technology [J].
Wang, Haopeng ;
Liu, Xueyan ;
Apostolidis, Panos ;
Scarpas, Tom .
JOURNAL OF CLEANER PRODUCTION, 2018, 177 :302-314
[95]   Effect of different coarse aggregate surface morphologies on cement emulsified asphalt adhesion [J].
Wang, Lusheng ;
Shen, Aiqin ;
Yao, Jialiang .
CONSTRUCTION AND BUILDING MATERIALS, 2020, 262
[96]   Quantitative measurement of energy utilization efficiency and study of influence factors in typical microwave heating process [J].
Wang, Wenlong ;
Zhao, Chao ;
Sun, Jing ;
Wang, Xiaolin ;
Zhao, Xiqiang ;
Mao, Yanpeng ;
Li, Xinning ;
Song, Zhanlong .
ENERGY, 2015, 87 :678-685
[97]   Cold recycling of reclaimed asphalt pavement towards improved engineering performance [J].
Wang, Yangyang ;
Leng, Zhen ;
Li, Xi ;
Hu, Chichun .
JOURNAL OF CLEANER PRODUCTION, 2018, 171 :1031-1038
[98]   Laboratory investigation on effects of microwave heating on early strength of cement bitumen emulsion mixture [J].
Wang, Zhenjun ;
Dai, Nan ;
Wang, Xiaofeng ;
Zhang, Jie ;
Guo, Haoyan .
CONSTRUCTION AND BUILDING MATERIALS, 2020, 236 (236)
[99]   Modelling the effects of temperature and loading rate on fatigue properties of hot mixed asphalt [J].
Wen, Haifang ;
Li, Xiaojun ;
Bhusal, Sushanta .
INTERNATIONAL JOURNAL OF PAVEMENT ENGINEERING, 2014, 15 (01) :51-57
[100]   Utilization of Foaming Technology in Warm-Mix-Asphalt Mixtures Containing Moist Aggregates [J].
Xiao, Feipeng ;
Punith, V. S. ;
Putman, Bradley ;
Amirkhanian, Serji N. .
JOURNAL OF MATERIALS IN CIVIL ENGINEERING, 2011, 23 (09) :1328-1337