Deformation Induced Martensitic Transformation and Its Initial Microstructure Dependence in a High Alloyed Duplex Stainless Steel

被引：15

作者：

Xie, Lin ^{[1
]}

Huang, Tian-Lin ^{[1
]}

Wang, Yu-Hui ^{[2
]}

Wu, Gui-Lin ^{[1
]}

Tsuji, Nobuhiro ^{[3
]}

Huang, Xiao-Xu ^{[1
,4
]}

机构：

[1] Chongqing Univ, Coll Mat Sci & Engn, Chongqing 400044, Peoples R China

[2] Yanshan Univ, Natl Engn Res Ctr Equipment & Technol Cold Strip, Qinhuangdao 066004, Peoples R China

[3] Kyoto Univ, Dept Mat Sci & Engn, Kyoto 6068501, Japan

[4] Tech Univ Denmark, Wind Energy Dept, Sect Mat Sci & Adv Characterizat, DK-4000 Roskilde, Denmark

来源：

STEEL RESEARCH INTERNATIONAL | 2017年 / 88卷 / 12期

关键词：

cold rolling; deformation induced martensitic transformation; duplex stainless steel; microstructure; STRAIN-INDUCED MARTENSITE; INDUCED-PLASTICITY; RETAINED AUSTENITE; GRAIN-SIZE; DUCTILITY; TEMPERATURE; BEHAVIOR; 304-STAINLESS-STEEL; NUCLEATION; STABILITY;

D O I：

10.1002/srin.201700169

中图分类号：

TF [冶金工业];

学科分类号：

0806 ;

摘要：

Deformation induced martensitic transformation (DIMT) usually occurs in metastable austenitic stainless steels. Recent studies have shown that DIMT may occur in the austenite phase of low alloyed duplex stainless steels. The present study demonstrates that DIMT can also take place in a high alloyed Fe-23Cr-8.5Ni duplex stainless steel, which exhibits an unexpectedly rapid transformation from gamma-austenite into alpha'-martensite. However, an inhibited martensitic transformation has been observed by varying the initial microstructure from a coarse alternating austenite and ferrite band structure to a fine equiaxed microduplex structure.

引用

页数：9

共 50 条

[1] Reverse martensitic transformation on the corrosion behavior of a 2304 lean duplex stainless steel
Assumpcao, Raphael F.
Georges, Mariana
Guo, Xiaolei
Farias, Francisco W. C.
Santos, Dagoberto B.
Frankel, Gerald S.
Sicupira, Dalila C.
CORROSION SCIENCE, 2025, 245
[2] Analysis of deformation induced martensitic transformation in stainless steels
Das, A.
Chakraborti, P. C.
Tarafder, S.
Bhadeshia, H. K. D. H.
MATERIALS SCIENCE AND TECHNOLOGY, 2011, 27 (01) : 366 - 370
[3] Kinetics of deformation induced martensitic transformation in a 304 stainless steel
Shin, HC
Ha, TK
Chang, YW
SCRIPTA MATERIALIA, 2001, 45 (07) : 823 - 829
[4] Microstructure and deformation behavior of metastable duplex stainless steel at high rolling reductions
Rys, Janusz
Cempura, Grzegorz
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2017, 700 : 656 - 666
[5] Deformation-Induced Martensitic Transformation in Laser Cladded 304 Stainless Steel Coatings
Zeuner, Andre T.
Gerdt, Leonid
Ostwald, Andrea
Grun, Peter
Barbosa, Maria
Kaspar, Jorg
Zimmermann, Martina
MATERIALS, 2022, 15 (18)
[6] Effect of superplastic deformation on the microstructure and orientation of austenite in 3207 duplex stainless steel
Li, J.
Ren, X.
Gao, X.
KOVOVE MATERIALY-METALLIC MATERIALS, 2020, 58 (03): : 195 - 202
[7] Martensitic Transformation Induced by Cold Deformation of Lean Duplex Stainless Steel Uns S32304
Tavares, S. S. M.
Pardal, J. M.
da Silva, M. R.
de Oliveira, C. A. S.
MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS, 2014, 17 (02): : 381 - 385
[8] Study of Formation and Reversion of the Martensitic Phase Induced by Deformation of Lean Duplex Stainless Steel
Mendonca, C. S. P.
Matos, R. A. G.
Mendes, J.
Melo, M. L. N. M.
Rodrigues, G.
da Silva, M. R.
Silva, G.
JOURNAL OF NONDESTRUCTIVE EVALUATION, 2018, 37 (03)
[9] Measurement and modeling of deformation-induced martensitic transformation in a metastable austenitic stainless steel under cyclic loadings
Luo, Cheng
Yuan, Huang
ACTA MATERIALIA, 2022, 238
[10] The influence of temperature on deformation-induced martensitic transformation in 301 stainless steel
Das, Yadunandan B.
Forsey, Alexander N.
Kelleher, Joe
Kabra, Saurabh
Fitzpatrick, Michael E.
Simm, Thomas H.
Gungor, Salih
Moat, Richard J.
MATERIALS SCIENCE AND TECHNOLOGY, 2018, 34 (17) : 2114 - 2125

← 1 2 3 4 5 →