The Effect of Molecular Weight on the Solubility Properties of Biocompatible Poly(ethylene succinate) Polyester

Poly(ethylene succinate) (PES) is one of the most promising biodegradable and biocompatible polyesters and is widely used in different biomedical applications. However, little information is available on its solubility and precipitation properties, despite that these solution behavior properties affect its applicability. In order to systematically study these effects, biodegradable and biocompatible poly(ethylene succinate) (PES) was synthesized using ethylene glycol and succinic acid monomers with an equimolar ratio. Despite the optimized reaction temperature (T = 185 degrees C) of the direct condensation polymerization, relatively low molecular mass values were achieved without using a catalyst, and the M-n was adjustable with the reaction time (40-100 min) in the range of similar to 850 and similar to 1300 Da. The obtained crude products were purified by precipitation from THF ("good" solvent) with excess of methanol ("bad" solvent). The solvents for PES oligomers purification were chosen according to the calculated values of solubility parameters by different approaches (Fedors, Hoy and Hoftyzer-van Krevelen). The theta-solvent composition of the PES solution was 0.3 v/v% water and 0.7 v/v% DMSO in this binary mixture. These measurements were also allowed to determine important parameters such as the coefficients A (=0.67) and B (=3.69 x 10(4)) from the Schulz equation, or the K-eta (=8.22 x 10(-2)) and alpha (=0.52) constants from the Kuhn-Mark-Houwink equation. Hopefully, the prepared PES with different molecular weights is a promising candidate for biomedical applications and the reported data and constants are useful for other researchers who work with this promising polyester.