A review of CCFL phenomenon

被引:57
作者
Al Issa, S. [1 ]
Macian, R. [1 ]
机构
[1] Tech Univ Munich, Inst Nucl Engn, Fac Mech Engn, D-85747 Garching, Germany
关键词
CCFL; Countercurrent; Hot-leg; Two-phase flows; Flooding; Review; GAS-LIQUID FLOW; COUNTERCURRENT 2-PHASE FLOW; NEAR-HORIZONTAL PIPE; PWR HOT LEG; INCLINED CHANNELS; LIMITATION; MODEL; PREDICTION; ELBOW; DRAG;
D O I
10.1016/j.anucene.2011.04.021
中图分类号
TL [原子能技术]; O571 [原子核物理学];
学科分类号
0827 ; 082701 ;
摘要
Counter current flow limitation CCFL is an important phenomenon for numerous engineering applications and safety of light water reactors. In particular, the possible occurrence of CCFL in the hot-leg of a PWR during SBLOCA or LOCA accidents is of special interest for nuclear safety research. A review of the related literature has made in order to present the most important studies about the phenomenon and to reach common general understanding of the different factors that govern CCFL Eventually this will allow explaining contradictions among different explanations provided by different authors. Most important factors were geometrical characteristics, liquid superficial velocity, and physical properties. The review shows that despite numerous experimental works, many scaling and geometrical effects are still not fully understood. For Instance there exist no consistent explanation of the channel diameter and inclined riser length effect upon results. The same can be stated-though to a minimum extent - for the inclination angle while channel length (or channel to diameter ratio) effect was clear and consistent. Since most experimental work was done in down-scaled hot-leg simulators, it becomes interesting to build a coherent knowledge about these effects and to explain arising contradictions in order to safely extrapolate results to full-scale hot-leg. The review has shown that many differences were simply due to geometrical effects, this leads to the need to "standardize" experimental data according to geometrical parameters. This should results in a better understanding of the phenomenon and corresponding scaling effects. Additionally, important variables such as: pressure drop, void fraction and shear stress were also investigated and discussed. A compilation of CCFL data was built and analyzed. Since the new simulation trends tend to use CFD codes where geometrical and spatial deviations are excluded by using 3D modeling, emphasis was placed upon introducing correlations for onset of CCFL out of collected data. Existing correlations for interfacial shear stress friction factor and the void fraction as a function of gas superficial velocity were also gathered and briefly discussed. The effect of condensation, physical parameters, and hysteresis upon CCFL was also introduced. (C) 2011 Elsevier Ltd. All rights reserved.
引用
收藏
页码:1795 / 1819
页数:25
相关论文
共 56 条
[41]   FLOODING IN AN ELBOW BETWEEN A VERTICAL AND A HORIZONTAL OR NEAR-HORIZONTAL PIPE .1. EXPERIMENTS [J].
SIDDIQUI, H ;
BANERJEE, S ;
ARDRON, KH .
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 1986, 12 (04) :531-541
[42]   BEHAVIOR OF LIQUID-FILMS AND FLOODING IN COUNTERCURRENT 2-PHASE FLOW .1. FLOW IN CIRCULAR TUBES [J].
SUZUKI, S ;
UEDA, T .
INTERNATIONAL JOURNAL OF MULTIPHASE FLOW, 1977, 3 (06) :517-532
[43]   MODEL FOR PREDICTING FLOW REGIME TRANSITIONS IN HORIZONTAL AND NEAR HORIZONTAL GAS-LIQUID FLOW [J].
TAITEL, Y ;
DUKLER, AE .
AICHE JOURNAL, 1976, 22 (01) :47-55
[44]  
Tien C. L., 1977, Letters in Heat and Mass Transfer, V4, P231, DOI 10.1016/0094-4548(77)90138-2
[45]  
Wallis G.B., 1961, UKAEA Report, AAEW-R 123
[46]  
Wallis G.B., 1973, INT J MULTIPHAS FLOW, V1, P173, DOI DOI 10.1016/0301-9322(73)90010-4
[47]  
Wallis G. B., 1969, One-Dimensional Two-phase Flow
[48]   A STUDY ON THE STRATIFIED HORIZONTAL COUNTERCURRENT 2-PHASE FLOW [J].
WANG, H ;
KONDO, S .
NUCLEAR ENGINEERING AND DESIGN, 1990, 121 (01) :45-52
[49]   SIMULATION AND ANALYSIS OF THERMAL-HYDRAULIC PHENOMENA IN A PWR HOT LEG RELATED TO SBLOCA [J].
WANG, MJ ;
MAYINGER, F .
NUCLEAR ENGINEERING AND DESIGN, 1995, 155 (03) :643-652
[50]  
WEISS P, 1992, ANS P NAT HEAT TRANS, V6, P268