Optimal design on SAW sensor for wireless pressure measurement based on reflective delay line

被引：58
|
作者：
Wang, Wen [1 ]
Lee, Keekeun [1 ]
Woo, Insang [1 ]
Park, Ikmo [1 ]
Yang, Sangsik [1 ]
机构：
[1] Ajou Univ, Div Elect Engn, Akron 443749, South Korea
来源：
SENSORS AND ACTUATORS A-PHYSICAL | 2007年 / 139卷 / 1-2期
关键词：
coupling of modes; reflectors; SAW reflective delay line; SPUDT wireless pressure sensor;
D O I：
10.1016/j.sna.2006.10.018
中图分类号：
TM [电工技术]; TN [电子技术、通信技术];
学科分类号：
0808 ; 0809 ;
摘要：
This paper presents optimal design on wireless pressure micro-sensor based on surface acoustic wave (SAW) reflective delay line. Using the coupling-of-modes (COM) analysis, the device was simulated, and the effect of reflector configuration and interdigital transducer (IDT) structure on the performance of the devices was studied. From the COM simulation results, a 440MHz SAW-based pressure sensor based on a reflective delay line on 4 V YX LiNbO3 with shorted circuit grating reflectors and single-phase unidirectional transducers (SPUDT) structure was developed experimentally. Using the network analyzer, the SAW sensor was wirelessly characterized, and the experiment results were well matched with simulation data. Sharp reflection peaks, low insertion loss and few spurious signals between the peaks were observed. Obtained pressure sensitivity was 2.67 degrees/kPa. (c) 2006 Elsevier B.V. All rights reserved.
引用
收藏
页码：2 / 6
页数：5
相关论文
共 50 条
  • [21] Wireless Remote 2-D Strain Sensor Using SAW Delay Line
    Nomura, T.
    Saitoh, A.
    MATERIALS AND DEVICES FOR SMART SYSTEMS III, 2009, 1129 : 33 - +
  • [22] Estimator for Reflective Delay Line-Type SAW Sensors
    Viikari, Ville
    Kokkonen, Kimmo
    Meltaus, Johanna
    Seppa, Heikki
    IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL, 2009, 56 (06) : 1277 - 1281
  • [23] SAW Reflective Delay Line Multi-transit Analysis
    Malocha, D. C.
    2016 IEEE International Frequency Control Symposium (IFCS), 2016, : 107 - 110
  • [24] Precise measurement of SAW velocity using SAW delay line
    Nomura, Tooru
    Yasuda, Tsutomu
    Shiokawa, Showko
    Moriizumi, Toyosaka
    IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1988, 35 (06): : 646 - 651
  • [25] Optimized design and fabrication of a wireless pressure and temperature sensor unit based on SAW transponder technology
    Schimetta, G
    Dollinger, F
    Scholl, G
    Weigel, R
    2001 IEEE MTT-S INTERNATIONAL MICROWAVE SYMPOSIUM DIGEST, VOLS 1-3, 2001, : 355 - 358
  • [26] A Love Wave Reflective Delay Line with Polymer Guiding Layer for Wireless Sensor Application
    Wang, Wen
    He, Shitang
    SENSORS, 2008, 8 (12) : 7917 - 7929
  • [27] A Novel Wireless PassiveTemperature-Pressure SAW-based Sensor
    Liwei ZHANG
    Tao GUO
    Qiulin TAN
    Yongwei ZHANG
    Tianhao ZHOU
    Instrumentation, 2019, 6 (01) : 109 - 115
  • [28] PRECISE MEASUREMENT OF SAW VELOCITY USING SAW DELAY-LINE
    NOMURA, T
    YASUDA, T
    SHIOKAWA, S
    MORIIZUMI, T
    IEEE TRANSACTIONS ON ULTRASONICS FERROELECTRICS AND FREQUENCY CONTROL, 1988, 35 (06) : 646 - 651
  • [29] Development of a surface acoustic wave wireless and passive temperature sensor incorporating reflective delay line
    WANG Wen
    XUE Xufeng
    SHAO Xiuting
    WANG Jianming
    LIANG Yong
    ChineseJournalofAcoustics, 2014, 33 (04) : 406 - 415
  • [30] TEMPERATURE SENSOR USING SAW DELAY-LINE
    HAUDEN, D
    JAILLET, G
    COQUEREL, R
    IEEE TRANSACTIONS ON SONICS AND ULTRASONICS, 1982, 29 (03): : 187 - 187
12345