Analysis, Design and Experimentation of a Closed-Loop Metal Halide Lamp Electronic Ballast

被引：0

作者：

Dalla Costa, M. A. ^{[1
]}

Alonso, J. M. ^{[1
]}

Garcia-Garcia, J. ^{[1
]}

Cardesin, J. ^{[1
]}

Ribas, J. ^{[1
]}

机构：

[1] Univ Oviedo, Area Tecnol Elect, Gijon 33204, Asturias, Spain

来源：

CONFERENCE RECORD OF THE 2006 IEEE INDUSTRY APPLICATIONS CONFERENCE, FORTY-FIRST IAS ANNUAL MEETING, VOL 1-5 | 2006年

关键词：

metal halide lamp; acoustic resonance; electronic ballast; square-waveform; closed-loop operation;

D O I：

暂无

中图分类号：

TE [石油、天然气工业]; TK [能源与动力工程];

学科分类号：

0807 ; 0820 ;

摘要：

This paper presents the analysis, design and experimentation of a closed-loop metal halide lamp ballast, which supplies the lamp with a low-frequency square waveform. First of all, a discussion related to the lamp parameter that should be regulated (power or current) is presented, since this issue has not been well addressed in previous literature. Experiments demonstrated that lamp current can be chosen to be kept constant during lamp life, because, on one hand, it can attenuate the effect of lumen depreciation with lamp ageing, and, on the other hand, the lamp power does not reach over-rated values during lamp life. In order to analyze the open-loop characteristic and design a suitable controller for the closed-loop operation, a dynamic model of the lamp-ballast system is developed,. Therefore, considering the dynamic of the lamp current sensor, a PI controller is proposed to minimize the steady state error and provide a phase margin of about 80 degrees (fully stable system). Experimental results using a flyback-based ballast supplied from a non-regulated DC voltage source (100 - 150V) are presented to validate the theoretical analysis. It is demonstrated that the lamp current is kept constant at rated value (0.42A) within the whole input voltage range. The time response of the complete closed-loop system is about 5 ms.

引用

页码：1384 / 1390

页数：7

共 14 条

[1] Alonso JM, 2006, APPL POWER ELECT CO, P1021
[2] Dynamic modelling of discharge lamps through step response
Alonso, JM
Dalla-Costa, MA
Martín-Ramos, JA
[J]. ELECTRONICS LETTERS, 2005, 41 (19) : 1078 - 1080
[3] Chen ST, 2004, APPL POWER ELECT CO, P991
[4] Costa MAD, 2005, IEEE IND APPLIC SOC, P1575
[5] Costa MAD, 2005, IEEE IND APPLIC SOC, P1198
[6] Low-cost electronic ballast to supply MH lamps based on flyback converter
Dalla Costa, MA
Alonso, JM
García, J
Cardesín, J
[J]. ELECTRONICS LETTERS, 2005, 41 (10) : 615 - 616
[7] de Groot J., 1986, HIGH PRESSURE SODIUM
[8] Deng E, 1997, APPL POWER ELECT CO, P1050, DOI 10.1109/APEC.1997.575779
[9] Huang CM, 2005, IEEE IND APPLIC SOC, P1193
[10] LI H, 2005, IEEE T IND APPL, V41

← 1 2 →