CMM touch trigger probes testing using a reference axis

被引：32

作者：

Dobosz, M ^{[1
]}

Wozniak, A ^{[1
]}

机构：

[1] Warsaw Univ Technol, Fac Mechatron, Inst Metrol & Measuring Syst, PL-02525 Warsaw, Poland

来源：

PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY | 2005年 / 29卷 / 03期

关键词：

coordinate measuring machines; dimensional metrology; touch trigger probe; probe pretravel;

D O I：

10.1016/j.precisioneng.2004.11.008

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

A new method of testing of touch trigger probes for coordinate measuring machines (CMM) has been proposed. The concept is based on measurements of the distance between reference and triggering points in various directions. The reference points are established by the rotation axis of a precise rotary table. The advantage of this method relies on easy realisation with application of a commercial device for roundness error measurement. The accuracy of the presented method is much higher in comparison with the existing procedures of CMM probes calibration. The mathematical principle of the method has been presented and used for evaluation of its uncertainty. The validity of the method was experimentally confirmed by means of one- and two-stage type probes. (c) 2005 Elsevier Inc. All rights reserved.

引用

页码：281 / 289

页数：9

共 20 条

[1]

*ANSI ASME, 1990, B89112M ANSIASME

[2]

BURDEKIN M, 1985, C P SOFTW COORD MEAS, P1

[3]

Butler C., 1991, Industrial Metrology, V2, P59, DOI 10.1016/0921-5956(91)80025-B

[4] Factors which influence CMM touch trigger probe performance [J].