SEM analysis on rock failure mechanism by supercritical CO2 jet impingement

Supercritical carbon dioxide (CO2) jet-assisted radial drilling is regarded as a potential alternative drilling method because supercritical CO2 jet has higher efficiency in rock-erosion efficiency than water jet. Although researchers have investigated how the rock-erosion performance by supercritical CO2 jet impingement correlates with the influencing parameters, there is little on the rock failure mechanism and change of pore structure. Scanning electron microscopy (SEM) analysis has been an important means in mineral identification, material damage detection, and aiding in water jet research. Therefore, rock erosion experiments and SEM observations and analyses were carried out on different rocks including sandstone, marble and so forth. Secondary electron (SE) images show obvious grain shapes on the complex impinged surface of sandstone and marble by supercritical CO2 jet, and cleavages on the mineral grains, and cracks and holes between the grains in different sizes. It suggests that cementations in weaker rocks are firstly removed and then mineral grains broken, generating the intergranular and intragranular cracks and micro-fractures and fissures. Supercritical CO2 jet cannot bring obvious changes to hard limestone and shale at the same condition because the rock substances are tightly packed and filled with large cementing forces and ultra-low permeability and porosity, but can produce a few micro-cracks vertical to bedding planes. The features show that supercritical CO2 jet broke rock substances mainly in the brittle tensile failure mechanism and made the rock much easier to further break, accompanied with shear failure mechanism in particular locations of the perforation hole. In contrast, water jet impingement forms flat cutting sections in marble with continuous parallel breaking traces, indicating the shear failure mechanism. Low viscosity and high diffusivity of supercritical CO2 are primarily attributed to the rock tensile failure mechanism, they facilitate supercritical CO2 penetrates into deep into rock pores and produces static pressure on the inner wall and at the tips of the fractures, besides exerting jet impinging pressure. Moreover, the energizing effect caused by the phase change from supercritical to gas leads to the energizing effect and intensify rock breaking into more shattered pieces and, concurrently, improve general rock connectivity and porosity in the surface layers. As a consequence, supercritical CO2 jet appears to be more efficient and suitable than water jet in slim-hole radial drilling and hydraulic fracturing, particularly in unconventional reservoirs with low permeability. (C) 2016 Elsevier B.V. All rights reserved.