Modeling the Influence of Engine Dynamics on Its Indicator Diagram

被引:4
|
作者
Deuszkiewicz, Piotr [1 ]
Dziurdz, Jacek [1 ]
Fabis, Pawel [2 ]
机构
[1] Warsaw Univ Technol, Inst Machine Design Fundamentals, PL-02524 Warsaw, Poland
[2] Silesian Tech Univ, Dept Transport & Aviat Engn, PL-40019 Katowice, Poland
关键词
internal combustion engine; indicator diagram; dynamics; TORSIONAL VIBRATION; DIESEL-ENGINE; COMBUSTION; PERFORMANCE; PARAMETERS; SIMULATION;
D O I
10.3390/s21237885
中图分类号
O65 [分析化学];
学科分类号
070302 ; 081704 ;
摘要
This article presents a proposal to describe the pressure changes in the combustion chamber of an engine as a function of the angle of rotation of the crankshaft, taking into account changes in rotational speed resulting from acceleration. The aim of the proposed model is to determine variable piston forces in simulation studies of torsional vibrations of a crankshaft with a vibration damper during the acceleration process. Its essence is the use of a Fourier series as a continuous function to describe pressure changes in one cycle of work. Such a solution is required due to the variable integration step during the simulation. It was proposed to determine the series coefficients on the basis of a Fourier transform of the averaged waveform of a discreet open indicator diagram, calculated for the registration of successive cycles. Recording of the indicative pressure waveforms and shaft angle sensor signals was carried out during tests on the chassis dynamometer. An analysis of the influence of the adopted number of series coefficients on the representation of signal energy was carried out. The model can also take into account the phenomenon of work cycle uniqueness by introducing random changes in the coefficients with magnitudes set on the basis of determined standard deviations for each coefficient of the series. An indispensable supplement to the model is a description of changes in the engine rotational speed, used as a control signal for the PID controller in the simulation of the load performed by the dynamometer. The accuracy of determining the instantaneous rotational speed was analyzed on the basis of signals from the crankshaft position angle sensor and the piston top dead center (TDC) sensor. Limitations resulting from the parameters of digital signal recording were defined.
引用
收藏
页数:18
相关论文
共 50 条
  • [41] Modeling and Analysis of Thermoelectric Generators for Diesel Engine Exhaust Heat Recovery System
    Wang, Jun
    Song, Xiangxiang
    Li, Yilin
    Zhang, Chaozhen
    Zhao, Chuang
    Zhu, Lei
    JOURNAL OF ENERGY ENGINEERING, 2020, 146 (02)
  • [42] Artificial Neural Network Modeling of Forming Limit Diagram
    Derogar, Ali
    Djavanroodi, Faramarz
    MATERIALS AND MANUFACTURING PROCESSES, 2011, 26 (11) : 1415 - 1422
  • [43] Numerical simulation research on the influence of the parameters of water injection on the GDI engine
    Zhang, Zhongjie
    Li, Aqian
    Zheng, Zhaolei
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2023, 24 (06) : 2568 - 2591
  • [44] Schematization of the Discharge Process in a Reciprocating Compressor Indicator Diagram
    V. E. Shcherba
    E. A. Dorofeev
    E. A. Pavlyuchenko
    Chemical and Petroleum Engineering, 2022, 57 : 747 - 755
  • [45] Schematization of the Discharge Process in a Reciprocating Compressor Indicator Diagram
    Shcherba, V. E.
    Dorofeev, E. A.
    Pavlyuchenko, E. A.
    CHEMICAL AND PETROLEUM ENGINEERING, 2022, 57 (9-10) : 747 - 755
  • [46] A comprehensive utilization of pentanol and its blends as diesel engine fuel: A review
    Celebi, Yahya
    Cengiz, Mazlum
    Aydin, Huseyin
    BIOMASS & BIOENERGY, 2025, 193
  • [47] Turbulent Reactive Flow Modeling in Engines: Simulating Engine Dynamics Using fearce
    Waters, Jiajia
    Carrington, David B.
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2020, 142 (02):
  • [48] Influence of surfactants on quaternary emulsion blend and experimental investigations on the influence of hydrogen enriched quaternary blend in DICI engine
    Kowthaman, C. N.
    Selvan, V. Arul Mozhi
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2020, 45 (42) : 22349 - 22363
  • [49] Emission Characteristics of Influence of Nano-Additives Doped Biofuel in a Diesel Engine
    Venu, Harish
    Joy, Nivin
    Reddy, Sagili Srikanth
    Subramanyam, Chimakurthy Venkata
    Jayaprabakar, J.
    Prabhu, A.
    3RD INTERNATIONAL CONFERENCE ON FRONTIERS IN AUTOMOBILE AND MECHANICAL ENGINEERING (FAME 2020), 2020, 2311
  • [50] Modeling and optimization of a typical fuel cell-heat engine hybrid system and its parametric design criteria
    Zhao, Yingru
    Chen, Jincan
    JOURNAL OF POWER SOURCES, 2009, 186 (01) : 96 - 103