Microstructure and microsegregation in Al-rich Al-Cu-Mg alloys

被引：106

作者：

Xie, FY ^{[1
]}

Kraft, T ^{[1
]}

Zuo, Y ^{[1
]}

Moon, CH ^{[1
]}

Chang, YA ^{[1
]}

机构：

[1] Univ Wisconsin, Dept Mat Sci & Engn, Madison, WI 53706 USA

来源：

ACTA MATERIALIA | 1999年 / 47卷 / 02期

基金：

美国国家科学基金会;

关键词：

D O I：

10.1016/S1359-6454(98)00372-3

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Microstructure and microsegregation in two directionally solidified Al alloys, Al-3.9Cu-0.9Mg and Al-15Cu-1Mg (in wt%), were investigated for cooling rates between 0.78 and 0.039 K/s. Transverse and longitudinal sections were examined to exhibit dendritic microstructures. Fractions of solids formed were determined using quantitative image analysis and solute redistribution in the primary phase was determined using area scans. The model employed to calculate microsegregation is based on the Scheil model but including solid-state diffusion, dendrite arm coarsening and undercooling of the dendrite tip and the formation of eutectic. The model-calculated results were found to be in good agreement with the experimentally determined concentration distributions in the primary a phase and the amounts of phases formed. It was found that the dendrite morphology was best described by a cylindrical arm geometry and that the accuracy of the phase diagram could have a significant influence on the microsegregation predictions. For the alloy with low copper content, two types of embedded droplets were observed. (C) 1999 Acta Metallurgica Inc. Published by Elsevier Science Ltd. All rights reserved.

引用

页码：489 / 500

页数：12