Low-temperature X-ray diffraction study of martensite lattice parameters in binary Ti-Ni alloys

Concentration and temperature dependency of the B19'-martensite lattice parameters (MLP) in binary Ti-Ni alloys as well as the effect of the structural state of a parent austenite on these parameters were studied using low-temperature X-ray diffraction analysis. The existence of a concentration dependence of the MLP found for the hyper-equiatomic nickel concentration range is proved for cryogenic temperature range and extended, at least, up to 51.2 at.% of nickel. Temperature dependency of MLP is observed in the studied nickel concentration range, and they are approximately the same for different alloys in the temperature range of stable martensite. During heating in the temperature range of the martensite existence, all parameters of the B19'-martensite monoclinic cell change towards the values of corresponding parameters of the austenite tetragonal cell with which they have "genetic" relations. The maximum transformation lattice strain calculated at the martensite-start temperature of each alloy, and, hence, the resource of the recoverable strain, are higher for pre-equiatomic and equiatomic alloys than that for alloys in hyper-equiatomic nickel concentration range. For Ti-50.7 at.% Ni alloy, the lattice parameters of martensite formed from the austenite containing a well-developed dislocation substructure deviate from the corresponding lattice parameters of the quenched martensite formed from a low-dislocated recrystallized austenite. This distinction is a general feature for the alloys undergoing B2 -> B19' and B2 -> R -> B19' martensitic transformations. (c) 2007 Elsevier B.V. All rights reserved.