Round impinging jets with relatively large stand-off distance

Large eddy simulation and particle image velocimetry measurements have been performed to evaluate the characteristics of a turbulent impinging jet with large nozzle height-to-diameter ratio (H/D = 20). The Reynolds number considered is approximately 28 000 based on the jet exit velocity and nozzle diameter. Mean normalized centerline velocity in both the free jet and impingement regions and pressure distribution over the plate obtained from simulations and experiments show good agreement. The ring-like vortices generated due to the Kelvin-Helmholtz instabilities at the exit of the nozzle merge, break down and transform into large scale structures while traveling towards the impingement plate. A Strouhal number of 0.63 was found for the vortices generated at the exit of the nozzle. However, this parameter is reduced along the centerline towards the impingement zone. A characteristic frequency was also determined for the large scale structures impinging on the plate. The expansion, growth, tilt, and three-dimensionality of the impinging structures cause dislocation of the impinging flow from the centerline, which is significantly larger when compared with flows having small H/D ratios. Contrary to the behavior of impinging jets with small stand-off distance, due to the loss of coherence, the large scale structures do not result in significant secondary vortices in the wall jet region and consequently less fluctuations were observed for wall shear stress. Published by AIP Publishing.