Comparison of life cycle performance of distributed energy system and conventional energy system for district heating and cooling in China

被引:4
作者
Liu Chang-rong [1 ]
Tang Yi-fang [2 ]
Wang Han-qing [1 ,3 ]
Liu Zhi-qiang [1 ]
Yang Sheng [1 ]
Li Chao-jun [4 ]
Jin Wen-ting [4 ]
机构
[1] Cent South Univ, Sch Energy Sci & Engn, Changsha 410083, Peoples R China
[2] Hunan Univ Sci & Technol, Sch Civil Engn, Xiangtan 411201, Peoples R China
[3] Cent South Univ Forestry & Technol, Sch Civil Engn, Changsha 410004, Peoples R China
[4] Hunan Univ Technol, Sch Civil Engn, Zhuzhou 412007, Peoples R China
基金
中国国家自然科学基金;
关键词
life-cycle assessment; distributed energy system; conventional energy system; building cooling and heating; environmental impact; MULTIOBJECTIVE OPTIMIZATION; SOLAR COLLECTORS; PUMP; DESIGN;
D O I
10.1007/s11771-022-5073-y
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
The distributed energy system has achieved significant attention in respect of its application for single-building cooling and heating. Researching on the life cycle environmental impact of distributed energy systems (DES) is of great significance to encourage and guide the development of DES in China. However, the environmental performance of distributed energy systems in a building cooling and heating has not yet been carefully analyzed. In this study, based on the standards of ISO14040-2006 and ISO14044-2006, a life-cycle assessment (LCA) of a DES was conducted to quantify its environmental impact and a conventional energy system (CES) was used as the benchmark. GaBi 8 software was used for the LCA. And the Centre of Environmental Science (CML) method and Eco-indicator 99 (EI 99) method were used for environmental impact assessment of midpoint and endpoint levels respectively. The results indicated that the DES showed a better life-cycle performance in the usage phase compared to the CES. The life-cycle performance of the DES was better than that of the CES both at the midpoint and endpoint levels in view of the whole lifespan. It is because the CES to DES indicator ratios for acidification potential, eutrophication potential, and global warming potential are 1.5, 1.5, and 1.6, respectively at the midpoint level. And about the two types of impact indicators of ecosystem quality and human health at the endpoint level, the CES and DES ratios of the other indicators are greater than 1 excepting the carcinogenicity and ozone depletion indicators. The human health threat for the DES was mainly caused by energy consumption during the usage phase. A sensitivity analysis showed that the climate change and inhalable inorganic matter varied by 1.3% and 6.1% as the electricity increased by 10%. When the natural gas increased by 10%, the climate change and inhalable inorganic matter increased by 6.3% and 3.4%, respectively. The human health threat and environmental damage caused by the DES could be significantly reduced by the optimization of natural gas and electricity consumption.
引用
收藏
页码:2357 / 2376
页数:20
相关论文
共 40 条
[1]   Performance assessment of a novel system using parabolic trough solar collectors for combined cooling, heating, and power production [J].
Al-Sulaiman, Fahad A. ;
Hamdullahpur, Feridun ;
Dincer, Ibrahim .
RENEWABLE ENERGY, 2012, 48 :161-172
[2]   Life Cycle Assessment of a solar thermal system in Spain, eco-design alternatives and derived climate change scenarios at Spanish and Chinese National levels [J].
Alberti, Jaume ;
Raigosa, Juliana ;
Raugei, Marco ;
Assiego, Rafael ;
Ribas-Tur, Joan ;
Garrido-Soriano, Maria ;
Zhang, Linghui ;
Song, Guobao ;
Hernandez, Patxi ;
Fullana-i-Palmer, Pere .
SUSTAINABLE CITIES AND SOCIETY, 2019, 47
[3]   Towards an optimal coverage of ecosystem services in LCA [J].
Alejandre, Elizabeth M. ;
van Bodegom, Peter M. ;
Guinee, Jeroen B. .
JOURNAL OF CLEANER PRODUCTION, 2019, 231 :714-722
[4]   Environmental performance of energy systems of residential buildings: Toward sustainable communities [J].
Anastaselos, Dimitrios ;
Oxizidis, Simeon ;
Manoudis, Alexandros ;
Papadopoulos, Agis M. .
SUSTAINABLE CITIES AND SOCIETY, 2016, 20 :96-108
[5]  
[Anonymous], 2006, ISO 14040 2006 ENV M, DOI DOI 10.1002/JTR
[6]   Life cycle impact assessment and interpretation of municipal solid waste management scenarios based on the midpoint and endpoint approaches [J].
Yi, Sora ;
Kurisu, Kiyo H. ;
Hanaki, Keisuke .
INTERNATIONAL JOURNAL OF LIFE CYCLE ASSESSMENT, 2011, 16 (07) :652-668
[7]   Life Cycle Impact Assessment Workshop Summary Midpoints versus Endpoints: The Sacrifices and Benefits [J].
Bare, Jane C. ;
Hofstetter, Patrick ;
Pennington, David W. ;
de Haes, Helias A. Udo .
INTERNATIONAL JOURNAL OF LIFE CYCLE ASSESSMENT, 2000, 5 (06) :319-326
[8]  
Brusseau M.L., 2019, Sustainable Development and Other Solutions to Pollution and Global Change, V3rd ed., DOI [10.1016/b978-0-12-814719-1.00032-x, DOI 10.1016/B978-0-12-814719-1.00032-X]
[9]  
Chapius S., 2009, PROC IBPSA C BUILDIN, P599
[10]   Multi-objective design optimization of distributed-energy systems through cost and exergy assessments [J].
Di Somma, M. ;
Yan, B. ;
Bianco, N. ;
Graditi, G. ;
Luh, P. B. ;
Mongibello, L. ;
Naso, V. .
APPLIED ENERGY, 2017, 204 :1299-1316