Research on the Performance of Pumpjet Propulsor of Different Scales

被引:5
作者
Yang, Jun [1 ]
Feng, Dakui [1 ]
Liu, Liwei [1 ]
Wang, Xianzhou [1 ]
Yao, Chaobang [1 ]
机构
[1] Huazhong Univ Sci & Technol, Sch Naval Architecture & Ocean Engn, Key Lab Ship & Ocean Hydrodynam Hubei Prov, Wuhan 430074, Peoples R China
基金
美国国家科学基金会;
关键词
RANS; overset grid; pumpjet propulsor; open-water performance; PROPELLER; SIMULATION; FLOW; JET; MODEL;
D O I
10.3390/jmse10010078
中图分类号
U6 [水路运输]; P75 [海洋工程];
学科分类号
0814 ; 081505 ; 0824 ; 082401 ;
摘要
This study presents a numerical research on the open-water performance of a pumpjet propulsor at different scales. Simulations were performed by an in-house viscous CFD (Computational Fluid Dynamic) code. The Reynolds-averaged Navier-Stokes (RANS) method with SST k-omega turbulence model is employed. A dynamic overset grid is used to treat the relative motion between the rotor and other parts. The numerical results are compared with the model test data and they agree well. Comparisons for the open-water performance between the pumpjet propulsors with two scales are carried out. The results indicate that the total thrust coefficient of the large-scale pumpjet propulsor is greater than that of the small-scale one while the torque coefficient is smaller. Therefore, the efficiency of the large-scale pumpjet propulsor is about 8~10% higher than that of the small-scale pumpjet propulsor. The open-water performance of the rotor, pre-swirl stator and duct is obtained separately to estimate the discrepancies on the thrust and torque coefficients between different scales. To analyze the scale effect from different parts, the research on flow field and pressure distribution are carried out. The variation of total thrust and torque coefficient comes mainly from the rotor, which is caused by the flow field, influenced by the duct and stator.
引用
收藏
页数:29
相关论文
共 50 条
[21]   Pulsating pressure control of pumpjet propulsor ducts with groove structures [J].
Ye J.-M. ;
Wu Y.-R. ;
Sun D.-P. ;
Zou X.-Y. .
Chuan Bo Li Xue/Journal of Ship Mechanics, 2024, 28 (02) :191-203
[22]   Effect of the duct and the pre-swirl stator on the wake dynamics of a pre-swirl pumpjet propulsor [J].
Qin, Denghui ;
Huang, Qiaogao ;
Pan, Guang ;
Shi, Yao ;
Han, Peng ;
Dong, Xinguo .
OCEAN ENGINEERING, 2021, 237
[23]   Effects of duct parameter on pump-jet propulsor unsteady hydrodynamic performance [J].
Huang, Qiaogao ;
Li, Han ;
Pan, Guang ;
Dong, Xinguo .
OCEAN ENGINEERING, 2021, 221
[24]   Hydrodynamic study of pumpjet propulsor with a ring at rotor tip and embedded in the groove of the inner wall of the duct [J].
Ye J.-M. ;
Sun D.-P. ;
Wu Y.-R. ;
Zhang X.-F. .
Chuan Bo Li Xue/Journal of Ship Mechanics, 2023, 27 (03) :323-334
[25]   Numerical simulation of hydrodynamic performance of pump-jet propulsor with serrated trailing-edge duct under different working conditions [J].
Sun, Yu ;
Qu, Li-xin ;
Peng, Huang-hua ;
Guo, Jia-min ;
Xiong, Zhi-xin .
OCEAN ENGINEERING, 2023, 290
[26]   Assessment of transition modeling for the unsteady performance of a pump-jet propulsor in model scale [J].
Li, Han ;
Huang, Qiaogao ;
Pan, Guang ;
Dong, Xinguo .
APPLIED OCEAN RESEARCH, 2021, 108
[27]   Prediction of Cavitation Performance over the Pump-Jet Propulsor Using Computational Fluid Dynamics and Hybrid Deep Learning Method [J].
Qiu, Chengcheng ;
Huang, Qiaogao ;
Pan, Guang .
JOURNAL OF MARINE SCIENCE AND ENGINEERING, 2022, 10 (07)
[28]   Propulsion performance and unsteady forces of a pump-jet propulsor with different pre-swirl stator parameters [J].
Yu, Haiting ;
Duan, Ningyuan ;
Hua, Hongxing ;
Zhang, Zhenguo .
APPLIED OCEAN RESEARCH, 2020, 100
[29]   Transient analysis of the pre-whirl pump-jet propulsor with different blade numbers [J].
Li, Fuzheng ;
Huang, Qiaogao ;
Pan, Guang ;
Wu, Bilin ;
Li, Han .
SHIPS AND OFFSHORE STRUCTURES, 2023, 18 (06) :846-858
[30]   Numerical analysis of unsteady hydrodynamic performance of pump-jet propulsor in oblique flow [J].
Qiu, Chengcheng ;
Pan, Guang ;
Huang, Qiaogao ;
Shi, Yao .
INTERNATIONAL JOURNAL OF NAVAL ARCHITECTURE AND OCEAN ENGINEERING, 2020, 12 :102-115