High speed machining of Inconel 718: tool wear and surface roughness analysis

被引：67

作者：

D'Addona, D. M. ^{[1
]}

Raykar, Sunil J. ^{[2
]}

Narke, M. M. ^{[3
]}

机构：

[1] Univ Naples Federico II, Dept Chem Mat & Ind Prod Engn, Fraunhofer Joint Lab Excellence Adv Prod Technol, Piazzale Tecchio 80, I-80125 Naples, Italy

[2] DY Patil Coll Engn & Technol, Kolhapur 416006, Maharashtra, India

[3] DY Patil Polytech, Kolhapur 416006, Maharashtra, India

来源：

10TH CIRP CONFERENCE ON INTELLIGENT COMPUTATION IN MANUFACTURING ENGINEERING - CIRP ICME '16 | 2017年 / 62卷

关键词：

High speed machining; Inconel; 718; Tool wear; Surface roughness; CUTTING FORCES; LIFE;

D O I：

10.1016/j.procir.2017.03.004

中图分类号：

X [环境科学、安全科学];

学科分类号：

08 ; 0830 ;

摘要：

Inconel 718 is a Nickel based Heat Resistance Super Alloy (HRSA) widely used in many aerospace applications. It possesses good properties like corrosion resistance, high strength and exceptional weldability. It is considered as one of the most difficult to cut alloy. Recently many researcher have focus in employing many machining strategies to improve machinability of Inconel 718. This paper presents High Speed Machining (HSM) of Inconel 718. Turning trials are conducted at various speed ranging from low to high (60 m/min, 90 m/min, 190 m/min, 255 m/min). Tool wear and surface roughness, which are two major aspects of machinability, have been discussed in this investigation. (C) 2017 The Authors. Published by Elsevier B.V.

引用

页码：263 / 268

页数：6

共 10 条

[1] The effects of cutting speed on tool wear and tool life when machining Inconel 718 with ceramic tools [J].