Development of the plasma facing components for the dome-liner component of the ITER divertor

On the basis of the design and the specification of the dome-liner elaborated by EFDA, a manufacturing route based on high temperature brazing has been developed and proved by means of the fabrication and testing of several samples and mock-ups. The dome is protected with tungsten armour tiles joined onto heat sinks obtained from a bimetallic plate made of precipitation hardened copper-chromium-zirconium alloy and stainless steel realized by explosion bonding. The brazed joint between the tun gsten tiles and the heat sink has been qualified by means of thermal fatigue tests on small-scale mock-ups in reactor relevant conditions. The properties of the explosion bonding joint between the front copper alloy plate to the rear steel backing has been assessed by means of an extensive metallurgical and mechanical test program according to the specification provided by EFDA. The dimensional stability during the fabrication route has been investigated by means of the realization of a relevant curved component that has been dimensionally tested after the completion of each step of the manufacturing route. The results of the experimental activity are presented and discussed in this paper. (c) 2005 Elsevier B.V. All rights reserved.