Ex-nitrate Co/SBA-15 catalysts prepared with calibrated silica grains: Information given by TPR, TEM, SAXS and WAXS

The aim of the present work was to check for the presence of an ordered array of Co-based nanoparticles in catalysts prepared by impregnation and by using the two-solvents technique with pentane and cyclohexane on a single SBA-15 batch (prepared by precipitation in strongly acidic conditions (HCl 2 mol L-1))Cobalt nitrate is used as a precursor for an at. Co/Si ratio of 0.03. Solids are characterized after heat treatments in oxidizing (up to 700 degrees C, 2 degrees C/min, under O-2 10% in vol./Ar) and reducing (up to 1000 degrees C, 7 degrees C/min, under a H-2 10% in vol./He) conditions. After oxidation up to 700 degrees C, characteristic spinel diffraction peaks are observed in WAXS. The relative intensities of these peaks suggest that Co3O4 dominates when using impregnation whereas mixed Co3-xSiO4 domains are formed when using the two-solvents technique. Broad and symmetrical when using pentane, the X-ray diffraction peaks are more asymmetric with cyclohexane. On a statistical scale, more asymmetric spinel particles are then formed with this solvent. Still with cyclohexane, a correlation diffraction peak at 0.6 degrees in SAXS is observed. Two TPR peaks before 500 C are associated with the reduction of Co3O4 particles into CoO and then metallic Co. Two other TPR peaks (a shoulder at 330-350 degrees C, a broad peak at 640-680 degrees C) indicate the presence of particularly small oxidized particles in strong interaction with silica (detected neither by XRD, nor by TEM). By reference to recently published data, additional reductions observed within the range 800-900 degrees C and 900-1000 degrees C are associated with cobalt silicate CO2SiO4 domains, respectively dispersed on the silica surface and bulk. In reduced samples, two main kinds of metallic particles are identified: (i) large and spherical particles (diameter > 20 nm) growing outside silica grains and often covered by a silica layer. These particles are polytypic face-centered cubic with some hexagonal intergrowths, (ii) smaller particles (diameter < 10 nm) which remain dispersed inside the silica grains and/or inside silica walls. In SAXS, there is no correlation peak but the diffusion background detected at the lowest angles can be associated with the diffusion due to the largest Co-based particles. (C) 2010 Elsevier Inc. All rights reserved.