Range-Angle Coupling and Near-Field Effects of Very Large Arrays in mm-Wave Imaging Radars

In order to improve the resolution of imaging radars, electrically large arrays and a high absolute modulation bandwidth are needed. For radar systems with simultaneously high range resolution and very large aperture, the difference in path length at the receiving antennas is a multiple of the range resolution of the radar, in particular for off-bore-sight angles of the incident wave. Therefore, the radar response of a target measured at the different receiving antennas is distributed over a large number of range cells. This behavior depends on the unknown incident angle of the wave and is, thus, denoted as range-angle coupling. Furthermore, the far-field (FF) condition is no longer fulfilled in short-range applications. Applying conventional signal processing and radar calibration techniques leads to a significant reduction of the resolution capabilities of the array. In this article, the key aspects of radar imaging are discussed when radars with both large aperture size and high absolute bandwidth are employed in short-range applications. Based on an initial mathematical formulation of the physical effects, a correction method and an efficient signal processing chain are proposed, which compensate for errors that occur with conventional beamforming techniques. It is shown by measurements that with an appropriate error correction an improvement of the angular resolution up to a factor of 2.5 is achieved, resulting in an angular resolution below 0.4 degrees with an overall aperture size of nearly 200 lambda(0).