A method for independent measurement of elastic modulus and Poisson's ratio of diamond-like carbon films

A simple method to measure the elastic modulus and Poisson's ratio of diamond-like carbon (DLC) films deposited on Si wafer was suggested. This method involved etching a side of Si substrate using the DLC him as an etching mask. The edge of DLC overhang free from constraint of Si substrate exhibited periodic sinusoidal shape. By measuring the amplitude and the wavelength of the sinusoidal edge, we can determine the strain of the film required to adhere to the substrate. Combined with independent stress measurement by laser reflection method, this method allows calculation of the biaxial elastic modulus, E/(1 - nu); where E is the Elastic modulus and nu Poisson's ratio Of the DLC films. By comparing the biaxial elastic modulus with plane-strain modulus, E/(1 - nu(2)), measured by nano-indentation, me could further determine the elastic modulus and Poisson's ratio, independently. This method was employed to measure the mechanical properties of DLC films deposited by C6H6 r.f. glow discharge at the deposition pressure 1.33 Pa. The elastic modulus, E, increased from 94 to 128 GPa as the negative bias voltage increased from 400 to 550 V. Poisson's ratio was estimated to be about 0.22 in this bias voltage range. For the negative bias voltages less than 400 V, however, the present method resulted in negative Poisson's ratio. The limitation of the present method was discussed.