Characterization of Particulate Matter Morphology and Volatility from a Compression-Ignition Natural-Gas Direct-Injection Engine

The particulate matter (PM) emitted from a single-cylinder compression-ignition, natural-gas engine fitted with a High-Pressure Direct-Injection (HPDI) system distinctly different from a duel fuel engine was investigated, and characterized by size distribution, morphology, mass-mobility exponent, effective density, volatility, mixing state, and primary particle size using transmission electron microscopy (TEM), and tandem measurements from differential mobility analyzers (DMA) and a centrifugal particle mass analyzer (CPMA). Six engine conditions were selected with varying load, speed, exhaust gas recirculation (EGR) fraction, and fuel delivery strategy. An increase in engine load increased both the number concentration and the geometric mean diameter of the particulate. The fraction of the number of purely volatile particles to total number of particles (number volatile fraction, NVF) was found to decrease as load increased, although at the lower speed, partially premixed mode, the lowest NVF. All size distributions were also found to be unimodal. The size-segregated ratio of the mass of internally mixed volatile material to total particle mass (mass volatile fraction, MVF) decreased with load and with particle mobility-equivalent diameter. A roughly constant amount of volatile material is likely produced at each engine mode, and the decrease in MVF is due to the increase in PM number with load. Effective density and mass-mobility exponent of the non-volatile soot at the different engine loads were the same or slightly higher than soot from traditional diesel engines. Denuded effective density trends were observed to collapse to approximately the same line, although engine modes with higher MVFs had slightly higher effective densities suggesting that the soot structures have collapsed into more dense shapes-a suspicion that is confirmed with TEM images. TEM results also indicated that primary particle size first decreases from low to medium load, then increases from medium to high load. An increase in EGR was also seen to increase primary particle size. Coefficients were determined for a relation that gives primary particle diameter as a function of projected area equivalent diameter. A decrease in load or speed results in a stronger correlation. Copyright 2015 American Association for Aerosol Research