Enzymatically modified peptide surfaces: towards general electrochemical sensor platform for protein kinase catalyzed phosphorylations

We hereby present an electrochemical approach for monitoring the three protein kinases sarcomarelated kinase (Src), extracellular signal-regulated kinase 1 (Erk1), and cyclin A-dependent kinase 2 (CDK2/cyclin A). The electrochemical sensor is based on the ability of kinases to transfer a redox-labeled phosphoryl group to surface-bound peptides that are highly specific substrates for the particular protein kinase (EGIYDVP, EPLTPSG, and HHASPRK, respectively). The detection method relies on the use of 5'-gamma-ferrocenoyl-ATP (Fc-ATP) as a co-substrate for peptide phosphorylation. The peptides themselves are attached to a Au substrate, which acts as the working electrode. In this process a Fc-phosphoryl group is transferred to the peptide and the presence of the redox active Fc group is detected electrochemically. All peptide films were fully characterized by cyclic voltammetry (CV), square wave voltammetry (SWV), and electrochemical impedance spectroscopy (EIS). Particular attention was given to the electron transfer rates, k(ET), in peptide films after Fc-phosphorylation which were found to be on the order of seconds. The slow ET kinetics is presumably a result of the negative charge on the phosphoryl group. Time-of-flight secondary ion mass spectrometry (TOF-SIMS) and X-ray photoelectron spectroscopy (XPS) experiments based on the peptide modified Au surfaces reveal significant ferrocene and phosphate group content introduced using the kinase-catalyzed phosphorylation reaction.