Development and material testing of OF-Cu/DS-Cu/OF-Cu triplex tube (dispersion strengthened copper clad with oxygen free-copper) and trial fabrication of a vertical target mock-up for ITER divertor

For the divertor target of the International Thermonuclear Experimental Reactor (ITER), an OF-Cu/DS-Cu/OF-Cu tripler-structured cooling tube has been newly fabricated through powder metallurgy and drawing, The tripler structure comprised an aluminium oxide (0.5 mass%) - dispersion strengthened copper core (DS-Cu) clad with oxygen free copper (OF-Cu), a compliant layer for joining to the carbon fiber composite (CFC) tiles, and with an inner skin which tightly grasps a twisted INCONEL tape to assist heat transfer. Physical and mechanical properties of the DS-Cu core after heat treatment at 850 degrees C for 600 s were investigated. Also, CFC brazability, fabricability and feasibility of the tripler tube for cooling channels for the divertor target were studied: A large scale vertical target mock-up of a 1500 mm length, 35 mm width and 3000 mm radius curved front face, has been fabricated, with nearly 50 pieces of "saddle"-shaped one-dimensional (1D)-CFC tiles were brazed on to 1500 mm long tripler tubes set in grooves of OF-Cu heat sink blocks joined to a stainless-steel back plate. The mock-up was tested under 20 MW/m(2) for 15 s for 1000 cycle thermal loadings, which simulated transient heat loadings of a vertical target of an ITER divertor. (C) 1998 Elsevier Science B.V. All rights reserved.