Thermal Conductivity Evaluation and Road Performance Test of Steel Slag Asphalt Mixture

Substituting steel slag for mineral materials in road construction has potential economic and environmental benefits. Due to the excellent thermal conductivity of steel slag, it is often used in functional pavements. However, there are few studies on the thermal conductivity characterization of steel slag asphalt mixture (SSAM). For this reason, the thermal conductivity of SSAM was first qualitatively evaluated by microscopic characterizations. The thermal conductivity was the quantitatively evaluated by the heating wire method. Theoretical calculations were used to verify the reliability of the quantitative characterization. Finally, the effects of steel slag on the volume indices and the road performance of SSAM were studied. Results showed that active minerals such as iron oxides make the steel slag thermally conductive, while a large number of protrusions and micropores on the surface of the steel slag may be detrimental to thermal conductivity. The thermal conductivity first increases and then decreases with the steel slag content. The asphalt mixture with 60% steel slag replacing aggregate of 3-5 mm (6.6% of the mixture) had the highest thermal coefficient of 1.746 W/(m center dot degrees C), which is only 4.78% different from the theoretical value. The porosity and water absorption of SSAM gradually increased with the content of steel slag. The road performance test indicated that steel slag increased the high-temperature performance of the asphalt mixture to a certain extent, but weakened the low-temperature performance and moisture resistance. After comprehensive consideration of the thermal conductivity and road performance, it is recommended that the optimum content of steel slag is not more than 60%.