Research of quasi 2-D refined simulation and modeling for deaerator in nuclear power plant

被引：8

作者：

Gong, Meijie ^{[1
]}

Peng, Minjun ^{[1
]}

Zhu, Haishan ^{[1
]}

机构：

[1] Harbin Engn Univ, Fundamental Sci Nucl Safety & Simulat Technol Lab, Harbin 150001, Peoples R China

来源：

ANNALS OF NUCLEAR ENERGY | 2020年 / 138卷

关键词：

Deaerator; Direct contact heat transfer; Quasi; 2-D; Parameter distribution; Dynamic process; CONTACT HEAT-EXCHANGER; DYNAMIC SIMULATION; STEAM; OPTIMIZATION; SYSTEM; WATER;

D O I：

10.1016/j.anucene.2019.107194

中图分类号：

TL [原子能技术]; O571 [原子核物理学];

学科分类号：

0827 ; 082701 ;

摘要：

Deaerator is an important component which is used widely in secondary loop system of nuclear power plant. In this work, the quasi 2-d simulation model for deaerator is developed. To make the simulation and modeling process more detailed and refined, some reasonable assumptions are proposed for mathematical modeling. There are two different zones of spraying zone and bubbling zone with more nodes. Simulating with practical physical process, the calculation process could demonstrate parameters distribution. In the steady state calculation and comparison, the simulation model is in good agreement comparing with design data onto actual nuclear power plant deaerator. The dynamic processes are validated by JTopmeret with main parameters. Two typical different dynamic processes are used to analyze deaerator operation characteristics. The refined different parameters distribution is calculated with time changing. It is real-time simulation model with such division that could guarantee the calculation speed and accuracy at the same time. (C) 2019 Elsevier Ltd. All rights reserved.

引用

页数：16

共 43 条

[1] Progress in dynamic simulation of thermal power plants [J].

Alobaid, Falah ;

Mertens, Nicolas ;

Starkloff, Ralf ;

Lanz, Thomas ;

Heinze, Christian ;

Epple, Bernd .

PROGRESS IN ENERGY AND COMBUSTION SCIENCE, 2017, 59 :79-162

[2] Temperature distribution measurements and modelling of a liquid-liquid-vapour spray column direct contact heat exchanger [J].

Baqir, Ali Sh. ;

Mahood, Hameed B. ;

Sayer, Asaad H. .

APPLIED THERMAL ENGINEERING, 2018, 139 :542-551

[3]

Batchelor G.K., 2010, INTRO FLUID DYNAMICS, P210

[4] Modeling a Direct Contact Heat Exchanger used in a supercritical water loop [J].

Cascella, F. ;

Teyssedou, A. .

APPLIED THERMAL ENGINEERING, 2015, 79 :132-139

[5] Dynamic modeling, simulation and optimization of a subcritical steam power plant. Part I: Plant model and regulatory control [J].

Chen, Chen ;

Zhou, Zhiquan ;

Bollas, George M. .

ENERGY CONVERSION AND MANAGEMENT, 2017, 145 :324-334

[6] Simulation investigation on the design and operation strategy of a 660 MW coal-fired power plant coupled with a steam ejector to ensure NOx reduction ability [J].

Chen, Weixiong ;

Li, Bingxin ;

Zhang, Shuangping ;

Liu, Ming ;

Liu, Jiping .

APPLIED THERMAL ENGINEERING, 2017, 124 :1103-1111

[7] ON PARTIAL DIFFERENCE EQUATIONS OF MATHEMATICAL PHYSICS [J].

COURANT, R ;

FRIEDRICHS, K ;

LEWY, H .

IBM JOURNAL OF RESEARCH AND DEVELOPMENT, 1967, 11 (02) :215-+

[8] Dynamical modeling and simulation of the six-modular high temperature gas-cooled reactor plant HTR-PM600 [J].

Dong, Zhe ;

Pan, Yifei ;

Zhang, Zuoyi ;

Dong, Yujie ;

Huang, Xiaojin .

ENERGY, 2018, 155 :971-991

[9] A lumped-parameter dynamical model of a nuclear heating reactor cogeneration plant [J].

Dong, Zhe ;

Pan, Yifei .

ENERGY, 2018, 145 :638-656

[10] Experimental and numerical studies of residence time in SK direct contact heat exchanger for heat pump [J].

Fu, Hailing ;

Ma, Lianjie ;

Wang, Haiyan .

CHEMICAL ENGINEERING RESEARCH & DESIGN, 2018, 135 :94-102

← 1 2 3 4 5 →