Effects of fuel properties and aerodynamic breakup on spray under flash boiling conditions

被引:15
作者
Zhao, Weihua [1 ,2 ]
Yan, Junhao [2 ]
Gao, Suya [2 ]
Lee, Timothy H. [2 ,3 ]
Li, Xiangrong [1 ]
机构
[1] Beijing Inst Technol, Sch Mech Engn, Beijing 100081, Peoples R China
[2] Univ Illinois, Dept Mech Sci & Engn, Champaign, IL 61801 USA
[3] Zhejiang Univ, ZJU UIUC Inst, Haining 314400, Zhejiang, Peoples R China
关键词
Flash boiling; Aerodynamic breakup; Fuel properties; Pressure ratio; Spray characteristics; Gasoline; GASOLINE; PRESSURE; ATOMIZATION; INJECTOR; VAPORIZATION; PERFORMANCE; EVAPORATION; COMBUSTION; MECHANISM; EMISSION;
D O I
10.1016/j.applthermaleng.2021.117646
中图分类号
O414.1 [热力学];
学科分类号
摘要
The main purpose of this work is to conduct detailed comparisons of spray behavior among four important components of gasoline and to investigate the effects of fuel properties and aerodynamic breakup on spray behavior under flash boiling conditions. Isooctane, hexane, pentane, and ethanol were used as test fuels. Pressure ratio (Rp) was used as an indicator for the superheated degree and varied from 0.14 to 1.1 by adjusting the ambient pressure. Both Diffused Backlight Imaging (DBI) and Phase Doppler Anemometry (PDA) measurements were used to obtain macroscopic and microscopic characteristics of sprays. Four dimensionless numbers were used to evaluate the aerodynamic breakup processes. The results showed that as the reduction of Rp, the flash boiling intensity increased, leading to dramatic spray morphology changes and smaller droplet size, regardless of fuel type. Spray plumes merged into the spray center when lowering Rp from 1.0. Spray collapsed at an Rp of 0.28 for isooctane, hexane, and ethanol, and at an Rp of 0.18 for pentane. Fuel properties also had significant effects on spray behaviors. Spray with pentane had the smallest penetration length, and a dramatic far-field angle reduction was observed at Rp between 0.2 and 0.4, due to its higher vapor pressure and lower latent heat of vaporization. Under the same Rp, ethanol sprays had relatively larger near-field angles, far-field angles, and Sauter mean diameter (SMD), due to its high latent heat of vaporization. All the dimensionless numbers showed that the spray with pentane had the largest aerodynamic breakup intensity, followed by hexane and isooctane, while ethanol had the lowest aerodynamic breakup intensity under the tested conditions. Aerodynamic breakup still played an important role under low flash boiling intensity conditions (Rp over 0.8). Microscopic results showed that SMD of isooctane, hexane, and pentane under an Rp of 0.28 had a similar value of 10 mu m.
引用
收藏
页数:10
相关论文
共 50 条
  • [21] Microscopic characterization of spray impingement under flash boiling conditions
    Wang, Ziman
    Dai, Xiaoyu
    Liu, Fushui
    Li, Zhishuang
    Li, Feng
    JOURNAL OF THE ENERGY INSTITUTE, 2019, 92 (03) : 640 - 652
  • [22] Flow in fuel nozzles under cavitation and flash-boiling conditions
    Xu, Huashi
    Wang, Tianyou
    Che, Zhizhao
    AIP ADVANCES, 2022, 12 (05)
  • [23] Investigation on flash boiling of superheated acetone spray under low vacuum conditions
    Thomas, Guillaume
    Vince, Maxence
    Spitzer, Denis
    APPLIED THERMAL ENGINEERING, 2025, 262
  • [24] Flash boiling in a multihole G-DI injector - Effects of the fuel distillation curve
    Araneo, Lucio
    Donde, Roberto
    FUEL, 2017, 191 : 500 - 510
  • [25] In-nozzle bubble formation and its effect on fuel jet breakup under cavitating and flash boiling conditions
    Yang, Shangze
    Wang, Shangning
    Sun, Zhe
    Li, Xuesong
    Hung, David L. S.
    Xu, Min
    APPLIED THERMAL ENGINEERING, 2021, 183
  • [26] The effects of nozzle taper angle on in-nozzle flow and nozzle tip-wetting under flash boiling conditions
    Wang, Shangning
    Xiao, Di
    Qiu, Shuyi
    Zhang, Xuan
    Li, Xuesong
    Hung, David L. S.
    Xu, Min
    FUEL, 2022, 329
  • [27] Spray characteristics of direct injection injectors with different nozzle configurations under flash-boiling conditions
    Chang, Mengzhao
    Park, Suhan
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2020, 159
  • [28] Study of component proportion effects on flash boiling atomization with ternary-alkane fuel mixtures
    Zhou, Xiaowei
    Zhai, Qiaozhi
    Hung, David L. S.
    Li, Xuesong
    Xu, Min
    FUEL, 2021, 298
  • [29] Local momentum flux measurement: An effective way for GDI spray targeting in flash boiling conditions
    Cavicchi, Andrea
    Postrioti, Lucio
    Sorbini, Giulio
    Brizi, Gabriele
    FUEL, 2022, 317
  • [30] Large eddy simulation investigation of ammonia spray characteristics under flash and non-flash boiling conditions
    Huang, Ziwei
    Wang, Haiou
    Luo, Kun
    Fan, Jianren
    APPLICATIONS IN ENERGY AND COMBUSTION SCIENCE, 2023, 16