Solidification behaviour and the effects of homogenisation on the structure of an Al-Cu-Mg-Ag-Sc alloy

被引:92
作者
Gazizov, Marat [1 ]
Teleshov, Viktor [2 ]
Zakharov, Valerij [2 ]
Kaibyshev, Rustam [1 ]
机构
[1] Belgorod State Univ, Lab Mech Properties Nanostruct Mat & Superalloys, Dept Mat Sci, Belgorod 308015, Russia
[2] All Russian Inst Light alloys, Moscow 121596, Russia
关键词
High-temperature alloy; Rapid-solidification; Precipitation; Thermal analysis; Scanning electron microscopy; X-ray diffraction; OMEGA-PHASE; ELEVATED-TEMPERATURES; GRAIN-REFINEMENT; EVOLUTION; SCANDIUM; KINETICS;
D O I
10.1016/j.jallcom.2011.07.050
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
The solidification behaviour and structural evolution during homogenisation annealing of a 0.17 mass% Sc and 0.1 mass% Ge modified Al-Cu-Mg-Ag alloy was examined. The formation of the primary Mg2Ge phase and the Sc-enriched theta-phase (Al2Cu) was found to occur under solidification; no evidence for the formation of the ternary W-phase (Al8-xCu4+xSc) was observed. Approximately 70% of the overall Sc content is fixed in the supersaturated solid solution. However, only two thirds of this Sc is consumed by the formation of a dispersion of nanoscale Al3Sc particles within the Al matrix under homogenisation annealing. A third of the Sc is consumed by the formation of the W-phase because of Sc diffusion into the primary theta-phase, which leads to its transformation into the W-phase. Finally, the W-phase consumes similar to 50% of the overall Sc content. No effects of homogenisation annealing on the volume fraction of Mg2Ge were observed. The optimal chemical composition of alloys in the Al-Cu-Mg-Ag-Sc system is discussed. (C) 2011 Elsevier B.V. All rights reserved.
引用
收藏
页码:9497 / 9507
页数:11
相关论文
共 36 条
[1]   The effect of silver on microstructural evolution in two 2xxx series Al-alloys with a high Cu:Mg ratio during ageing to a T8 temper [J].
Bakavos, D. ;
Prangnell, P. B. ;
Bes, B. ;
Eberl, F. .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2008, 491 (1-2) :214-223
[2]   Thermodynamic analysis of Al-Sc, Cu-Sc and Al-Cu-Sc system [J].
Bo, H. ;
Liu, L. B. ;
Jin, Z. P. .
JOURNAL OF ALLOYS AND COMPOUNDS, 2010, 490 (1-2) :318-325
[3]  
Chadwick G.A., 1972, Metallography of Phase Transformations
[4]   COMPOSITION AND STABILITY OF OMEGA-PHASE IN AN AL-CU-MG-AG ALLOY [J].
CHANG, YC ;
HOWE, JM .
METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1993, 24 (07) :1461-1470
[5]   Conversion of MX nitrides to Z-phase in a martensitic 12% Cr steel [J].
Cipolla, Leonardo ;
Danielsen, Hilmar K. ;
Venditti, Dario ;
Di Nunzio, Paolo Emilio ;
Hald, John ;
Somers, Marcel A. J. .
ACTA MATERIALIA, 2010, 58 (02) :669-679
[6]   In situ small-angle scattering study of the precipitation kinetics in an Al-Zr-Sc alloy [J].
Deschamps, A. ;
Lae, L. ;
Guyot, P. .
ACTA MATERIALIA, 2007, 55 (08) :2775-2783
[7]   ACCOMMODATION OF THE MISFIT STRAIN SURROUNDING (III) PRECIPITATES (OMEGA) IN AL-CU-MG-(AG) [J].
FONDA, RW ;
CASSADA, WA ;
SHIFLET, GJ .
ACTA METALLURGICA ET MATERIALIA, 1992, 40 (10) :2539-2546
[8]  
GAZIZOV MR, 2010, TECH LIGHT ALL, V4, P27
[9]   The effect of cooling rate on the morphology of primary Al3Se intermetallic particles in Al-Sc alloys [J].
Hyde, KB ;
Norman, AF ;
Prangnell, PB .
ACTA MATERIALIA, 2001, 49 (08) :1327-1337
[10]   Continuous dynamic recrystallization in an Al-Li-Mg-Sc alloy during equal-channel angular extrusion [J].
Kaibyshev, R ;
Shipilova, K ;
Musin, F ;
Motohashi, Y .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2005, 396 (1-2) :341-351