Investigation of Quench Sensitivity of an Al-7.5Zn-1.7Mg-1.4Cu-0.12Zr Alloy

被引:7
作者
Xiong, Baiqing [1 ]
Li, Xiwu [1 ]
Zhang, Yongan [1 ]
Li, Zhihui [1 ]
Zhu, Baohong [1 ]
Wang, Feng [1 ]
Liu, Hongwei [1 ]
机构
[1] Gen Res Inst Nonferrous Met, State Key Lab Nonferrous Met & Proc, Beijing 100088, Peoples R China
来源
THERMEC 2011, PTS 1-4 | 2012年 / 706-709卷
关键词
Al-Zn-Mg-Cu alloy; Quench sensitivity; TIP curve; Precipitate;
D O I
10.4028/www.scientific.net/MSF.706-709.431
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
In the present work, quench sensitivity of an A1-7.5Zn-1.7Mg-1.4Cu-0.12Zr alloy is investigated by temperature-time-property (TTP) curve and TEM analysis, comparing with traditional AA 7B04 and AA 7150. The results indicate that the nose temperature of TTP curve and the corresponding incubation period of the alloy, AA 7150 and AA 7B04 are about 290 degrees C/4.5s, 320 degrees C/2.6s and 335 degrees C/0.1s, respectively, The nose temperature of the alloy is the lowest among three alloys and the critical time at the nose temperature is the longest for the alloy, which is obvious that the alloy has lower quench sensitivity. Further TEM analysis shows that, with the prolongation of keeping time at the nose temperature, quench-induced precipitation phenomenon becomes obvious.
引用
收藏
页码:431 / 435
页数:5
相关论文
共 50 条
  • [41] Influence of Cr and Yb Alloying on the Microstructures and Fracture Characteristics of Al-Zn-Mg-Cu-Zr Alloy
    Fang Huachan
    Chen Kanghua
    Zhang Zhuo
    Liu Gang
    RARE METAL MATERIALS AND ENGINEERING, 2009, 38 (11) : 1960 - 1964
  • [42] Effects of Zr addition on solidification characteristics of Al-Zn-Mg-Cu alloy using thermal analysis
    Mostafapoor, Saman
    Malekan, Mehdi
    Emamy, Masoud
    JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2018, 134 (03) : 1457 - 1469
  • [43] Effect of Thermomechanical Treatment on Microstructure and Properties of Al-Zn-Mg-Cu Alloy
    Zhang, Weijian
    Su, Ruiming
    Li, Guanglong
    Qu, Yingdong
    TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS, 2025, 78 (05)
  • [44] Cryogenic deformation behavior of Al-Zn-Mg-Cu alloy and its sensitivity to temperature and strain rate
    Zhang, Mingli
    Gu, Kaixuan
    Pan, Ran
    Liu, Baosheng
    Weng, Zeju
    Wang, Junjie
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2024, 893
  • [46] Effect of one-step aging on microstructure and properties of a novel Al-Zn-Mg-Cu-Zr alloy
    XiWu Li
    BaiQing Xiong
    YongAn Zhang
    Cheng Hua
    Feng Wang
    BaoHong Zhu
    HongWei Liu
    Science in China Series E: Technological Sciences, 2009, 52 : 67 - 71
  • [47] Effect of combined addition of Zr, Ti and Y on microstructure and tensile properties of an Al-Zn-Mg-Cu alloy
    Li, Jiaheng
    Zhang, Yingbo
    Li, Mojia
    Hu, Yunfeng
    Zeng, Qi
    Zhang, Pu
    MATERIALS & DESIGN, 2022, 223
  • [48] Effect of one-step aging on microstructure and properties of a novel Al-Zn-Mg-Cu-Zr alloy
    Li XiWu
    Xiong BaiQing
    Zhang YongAn
    Hua Cheng
    Wang Feng
    Zhu BaoHong
    Liu HongWei
    SCIENCE IN CHINA SERIES E-TECHNOLOGICAL SCIENCES, 2009, 52 (01): : 67 - 71
  • [49] Effects of Excessive Zr Content and Ultrasonic Treatment on Microstructure and Mechanical Properties of Al-Zn-Mg-Cu Alloy
    Li, Cheng
    Wu, Shusen
    Lu, Shulin
    Li, Jianyu
    Liu, Longfei
    Xia, Lanqing
    METALS, 2021, 11 (04)
  • [50] Effects of alloy contents on strength and toughness in Al-Zn-Mg-Cu alloy
    Iwamura S.
    Minoda T.
    Yoshida H.
    Keikinzoku/Journal of Japan Institute of Light Metals, 2010, 60 (02): : 75 - 80