Comparison power generation by using thermoelectric modules between cooling module and power module for low temperature application

被引：0
|
作者：
Maneewan, S. [1 ]
Zeghmati, B. [2 ]
机构：
[1] Naresuan Univ, Thermal Energy & Energy Conservat Promot Res Unit, Dept Phys, Fac Sci, Phitsanulok 65000, Thailand
[2] Univ Perpignan, Lab Math & phys Syst MEPS, F-66860 Perpignan, France
来源：
PROCEEDINGS ICT 07: TWENTY-SIXTH INTERNATIONAL CONFERENCE ON THERMOELECTRICS | 2008年
关键词：
thermoelectric power generation; solar energy; waste heat from biomass drying; energy cost;
D O I：
暂无
中图分类号：
TM [电工技术]; TN [电子技术、通信技术];
学科分类号：
0808 ; 0809 ;
摘要：
The paper presents comparison thermoelectric power generation between cooling and power modules. In order to investigate which type of TE module is suitable for the power generation at low temperature of hot side of TE, four TE modules were considered: two TE cooling modules (TE model TEC1-12708 and MT2-1.-127) and two TE power modules (TE model TEP1-1264-3.4 and TEG1-1260-5.1) for by investigation temperature between 25 to 230 degrees C and resistance were 0, 5, 10, 15 and 20 Ohm. The results of this research found that thermoelectric model TECl-12708 could be the highest power generation about 0.98 watt and energy cost about 3-11 Bath/kWh (0.09-0.35 US$/kWh) depend on resistance of load, consequently thermoelectric cooling module was be proper to generated electric current at low temperature.
引用
收藏
页码：295 / 298
页数：4
相关论文
共 50 条
  • [1] Thermoelectric module construction for low temperature gradient power generation
    Meydbray, Y
    Singh, R
    Shakouri, A
    ICT: 2005 24th International Conference on Thermoelectrics, 2005, : 348 - 351
  • [2] Parametric study of a thermoelectric module used for both power generation and cooling
    Luo, Ding
    Wang, Ruochen
    Yu, Wei
    Zhou, Weiqi
    RENEWABLE ENERGY, 2020, 154 (154) : 542 - 552
  • [3] The Effect of Temperature Mismatch on Interconnected Thermoelectric Module for Power Generation
    Hakim, Ameer
    Lim, Joon Hoong
    13TH INTERNATIONAL ENGINEERING RESEARCH CONFERENCE (13TH EURECA 2019), 2020, 2233
  • [4] Research on Power Generation Performance of Stacked Thermoelectric Power Generation Module
    Song, Zhao
    Yang, Jiazhi
    Jiang, Cunbo
    Yin, Xinzhe
    Sun, Cheng
    2019 4TH INTERNATIONAL CONFERENCE ON MECHANICAL, CONTROL AND COMPUTER ENGINEERING (ICMCCE 2019), 2019, : 107 - 111
  • [5] Analysis of Cooling System of Thermoelectric Module for Power Generation using Denitrification Plant Heat Source
    Go, Sung Gon
    Park, Sang Jin
    Kim, Tae Wha
    Kim, Young Wook
    Suh, Jeong Se
    TRANSACTIONS OF THE KOREAN SOCIETY OF MECHANICAL ENGINEERS B, 2023, 47 (10) : 519 - 525
  • [6] Design of a novel thermoelectric module based on application stability and power generation
    Liu, Lin
    Meng, Xiangning
    Miao, Zhuang
    Zhou, Sen
    CASE STUDIES IN THERMAL ENGINEERING, 2022, 31
  • [7] EFFECT OF COOLING CONDITION ON THE PERFORMANCE OF THERMOELECTRIC POWER GENERATION SYSTEM COUPLING WITH PCM MODULE
    Zou, Jiapu
    Wu, Zihua
    Liu, Anbang
    Feng, Shi
    Xie, Huaqing
    THERMAL SCIENCE, 2022, 26 (02): : 1289 - 1299
  • [8] A Study on the Preparation Method of Thermoelectric Power Generation Module
    Liang, Taohua
    Yang, Shiqing
    Chen, Zhi
    Meng, Yifeng
    2018 INTERNATIONAL CONFERENCE OF GREEN BUILDINGS AND ENVIRONMENTAL MANAGEMENT (GBEM 2018), 2018, 186
  • [9] A 3D TCAD Simulation of a Thermoelectric Module configured for Thermoelectric Power Generation, Cooling and Heating
    Gould, C. A.
    Shammas, N. Y. A.
    Grainger, S.
    Taylor, I.
    Simpson, K.
    9TH EUROPEAN CONFERENCE ON THERMOELECTRICS (ECT2011), 2012, 1449 : 65 - 68
  • [10] Thermoelectric interface materials: A perspective to the challenge of thermoelectric power generation module
    Liu, Weishu
    Bai, Shengqiang
    JOURNAL OF MATERIOMICS, 2019, 5 (03) : 321 - 336
12345