Quantitative stress analysis of recrystallized OFHCCu subject to deformation in situ

Quantitative strain analysis (QSA) provides a means for assessing the orientation-dependent micromechanical stress states in bulk polycrystalline materials. When combined with quantitative texture analysis, it facilitates tracking the evolution of micromechanical states associated with selected texture components for specimens deformed in situ. To demonstrate this ability, a sheet specimen of rolled and recrystallized oxygen-free high conductivity Cu was subject to tensile deformation at APS 1-ID-C. Strain pole figures (SPFs) were measured at a series of applied loads, both below and above the onset of macroscopic yielding. From these data, a lattice strain distribution function (LSDF) was calculated for each applied load. Due to the tensorial nature of the LSDF the full orientation-dependent stress tensor fields can be calculated unambiguously from the single-crystal elastic moduli. The orientation distribution function (ODF) is used to calculate volume-weighted average stress states over tubular volumes centered on the < 100 >parallel to[100], < 311 >parallel to[100], and < 111 >parallel to[100] fibers-accounting for approximate to 50% of the total volume-are shown as functions of the applied load along [100]. Corresponding weighted standard deviations are calculated as well. Different multiaxial stress states are observed to develop in the crystal subpopulations despite the uniaxial nature of the applied stress. The evolution of the orientation-dependent elastic strain energy density is also examined. The effects of applying stress bound constraints on the SPF inversion are discussed, as are extensions of QSA to examine defect nucleation and propagation.