Bearing capacity of model piles driven into dense overconsolidated sands

Model piles were driven into dense siliceous sand samples and tested in a large calibration chamber. Axial tension and compression tests; were performed on open-ended pipe piles. The objective of this research was to study the effect of overconsolidation on the bearing capacity of piles driven into dense sands representative of North Sea soil conditions. Emphasis was put on points of interest for the offshore petroleum industry in particular: dense to very dense normally consolidated (NC) and overconsolidated (OC) sands, unit end bearing and unit skin friction capacities, and comparison with tip resistances from cone penetration tests. Design parameters are proposed for computing the axial bearing capacity of piles driven into dense to very dense siliceous sands. They are compared with those given in the current American Petroleum Industry's Recommended Practice 2A document. A relationship between CPT cone resistance and ultimate unit end bearing and skin friction capacities of piles is also proposed.