EXPERIMENTAL STUDY OF STRUCTURE FORMATION OF EUTECTIC BY ELECTRON MICROSCOPY IN NEW AS CAST Al-Cu15-Mg-Ti ALLOYS

被引：0
作者：
Zlaticanin, Biljana [1 ]
机构：
[1] Univ Montenegro, Fac Met & Technol, Podgorica 81000, Montenegro
来源：
FRESENIUS ENVIRONMENTAL BULLETIN | 2022年 / 31卷 / 1A期
关键词：
Al-Cul 5-Mg -Ti system; Al2Cu phase; Al2CuMg phase; crystal structure; ALUMINUM; MICROSTRUCTURE;
D O I：
暂无
中图分类号：
X [环境科学、安全科学];
学科分类号：
08 ; 0830 ;
摘要：
Two new as -cast alloys based on high copper Al-Cu15-Mg-Ti system were developed. The microstructure of the Al-Cu15-Mg-Ti alloys mainly consists of c( -Al, Al2Cu and Al2CuMg phases. In this paper, the structure of eutectic Al2Cu and Al2CuMg phases in Al-Cu15-Mg-Ti system has been determined by using a high-resolution electron microscopy. The Al-Cu 15-Mgt-Ti and Al-Cul5-Mg5-Ti alloys had similar microstructures that consisted of et -Al grains and eutectic structure. With the increase in eutectic fraction the hardness and strength of AlCul5-Mg-Ti alloys increased.
引用
收藏
页码：1034 / 1044
页数：11
相关论文
共 35 条
  • [21] Structure-property models in Al-Zn-Mg-Cu alloys: A critical experimental assessment of shape castings
    Ghiaasiaan, Reza
    Shankar, Sumanth
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2018, 733 : 235 - 245
  • [22] Investigating the failure behavior of cast Al-11Ce-0.4Mg alloys using in-situ scanning electron microscopy tensile testing
    Lane, Ryan J.
    Kesler, Michael S.
    Nawaz, Kashif
    Mirzaeifar, Reza
    JOURNAL OF ALLOYS AND COMPOUNDS, 2023, 947
  • [23] Effect of Al-5Ti-1B-xCe Refiner on Microstructure and Mechanical Properties of Cast Al-5Mg-3Zn-1Cu Alloys
    Cui, Shenshen
    Lu, Qiang
    Wang, Qudong
    Li, Dezhi
    Lei, Chuan
    METALS, 2025, 15 (02)
  • [24] High-Resolution Electron Microscopy and Kinetic Studies of Precipitation Hardening Reactions in Cast Al-5.8Zn-2.2Mg-2.5Cu
    Ghiaasiaan, S. Reza
    Amirkhiz, Babak Shalchi
    Shankar, Sumanth
    JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2019, 28 (08) : 4630 - 4646
  • [25] Study of the Microstructure, Crystallographic Structure and Thermal Stability of Al–Ti–Nb Alloys Produced by Selective Electron Beam Alloying
    Valkov S.
    Neov D.
    Bezdushnyi R.
    Beskrovnyi A.
    Kozlenko D.
    Petrov P.
    Journal of Surface Investigation: X-ray, Synchrotron and Neutron Techniques, 2018, 12 (3) : 436 - 441
  • [26] Fine precipitation scenarios of AlZnMg(Cu) alloys revealed by advanced atomic-resolution electron microscopy study Part I: Structure determination of the precipitates in AlZnMg(Cu) alloys
    Liu, J. Z.
    Chen, J. H.
    Yuan, D. W.
    Wu, C. L.
    Zhu, J.
    Cheng, Z. Y.
    MATERIALS CHARACTERIZATION, 2015, 99 : 277 - 286
  • [27] High- and low-cycle fatigue influence of silicon, copper, strontium and iron on hypo-eutectic Al-Si-Cu and Al-Si-Mg cast alloys used in cylinder heads
    Huter, Patrik
    Renhart, Philipp
    Oberfrank, Stefan
    Schwab, Martin
    Gruen, Florian
    Stauder, Bernhard
    INTERNATIONAL JOURNAL OF FATIGUE, 2016, 82 : 588 - 601
  • [28] Phase formation in as-solidified and heat-treated Al-Si-Cu-Mg-Ni alloys: Thermodynamic assessment and experimental investigation for alloy design
    Farkoosh, A. R.
    Javidani, M.
    Hoseini, M.
    Larouche, D.
    Pekguleryuz, M.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2013, 551 : 596 - 606
  • [29] Experimental and numerical study of the compressive fatigue behavior of a Ti6Al4V mapped rhombioidal dodecahedral structure fabricated by electron beam melting
    Yu, Boning
    Li, Yuming
    Abbes, Boussad
    Li, Shujun
    Yu, Baoyi
    INTERNATIONAL JOURNAL OF FATIGUE, 2023, 177
  • [30] Formation mechanism of cellular structure of Ni32.5Co15Cr10Fe23Al17.5Mo1.5W0.5 eutectic high-entropy alloys by selective laser melting
    Xie, An
    Yu, Huan
    Bai, Xiaoyu
    Wang, Zhijun
    Li, Junjie
    Wang, Jincheng
    He, Feng
    MATERIALS RESEARCH LETTERS, 2025, 13 (03): : 274 - 281
1234