Influence of fibre length and concentration on the properties of glass fibre-reinforced polypropylene .3. Strength and strain at failure

In this report we present the results from the third part of a study on the influence of fibre length (0.1-50 mm) and concentration (3-60% w/w) on the properties of glass fibre-reinforced polypropylene laminates. These laminates were prepared in the laboratory using a wet deposition method and compared with samples prepared on a commercial melt impregnation GMT line. We found that laminate tensile strength increased linearly with fibre concentration up to 60% w/w. Laminate strength was also found to increase with increasing fibre length. At high values of fibre length (> 3-6 mm) the strength reached a plateau level which was directly dependent on fibre content. The matrix molecular weight appeared to have little direct influence on the level of laminate strength. However, the glass fibre sizing compatibility was found to have a strong effect on the tensile strength of both laboratory made wet deposited laminates and commercially prepared GMTs. The tensile strength of the GMT samples also showed a clear correlation with the measured fibre strength. A modified version of the Kelly-Tyson model gave calculated values of laminate strength which correlated well with the experimental data. We propose that the tensile strength of these laminates is governed by the properties of the fibres which have an orientation close to parallel with the loading direction. Copyright (C) Elsevier Science Limited