The effect of agitated drying on the morphology of L-threonine (needle-like) crystals

被引:82
作者
Lekhal, A
Girard, KP
Brown, MA
Kiang, S
Khinast, JG
Glasser, BJ [1 ]
机构
[1] Rutgers State Univ, Dept Chem & Biochem Engn, Piscataway, NJ 08854 USA
[2] Bristol Myers Squibb Co, New Brunswick, NJ 08903 USA
关键词
drying; crystal; attrition; agglomeration; needle-like; pharmaceuticals;
D O I
10.1016/j.ijpharm.2003.10.022
中图分类号
R9 [药学];
学科分类号
1007 ;
摘要
Experiments have been carried out to study the behavior Of L-threonine (needle-like) crystals during agitated drying. For an L-threonine/water system the morphology of the crystals was monitored using light microscopy and image analysis. Analysis of the transient behavior of the crystal size and shape distribution showed that attrition and agglomeration took place simultaneously during the process. The variation of the operating conditions (temperature, agitation and vacuum) revealed that attrition dominated the drying process when the drying rate was low and/or the shear rate was high. For high drying rates and low shear rates, agglomeration became dominant. This study suggests that crystal redissolution had no significant impact on crystal morphology. It was also found that due to their needle-like shape, large L-threonine crystals were very sensitive to attrition. When attrition controlled the drying process, most of the particle size reduction took place below a critical moisture content of 4%. When agglomeration controlled the drying process, most of the crystal size enlargement occurred below a moisture content of 6%. (C) 2003 Elsevier B.V. All rights reserved.
引用
收藏
页码:263 / 277
页数:15
相关论文
共 24 条
[11]   Impact of agitated drying on crystal morphology: KCl-water system [J].
Lekhal, A ;
Girard, KP ;
Brown, MA ;
Kiang, S ;
Glasser, BJ ;
Khinast, JG .
POWDER TECHNOLOGY, 2003, 132 (2-3) :119-130
[12]   PARTICLE FLOW AND CONTACT HEAT-TRANSFER CHARACTERISTICS OF STIRRED GRANULAR BEDS [J].
MALHOTRA, K ;
MUJUMDAR, AS .
DRYING TECHNOLOGY, 1992, 10 (01) :51-80
[13]   Identification of impact attrition mechanisms in solution by morphological analysis [J].
Marrot, B ;
Pons, MN ;
Biscans, B .
CHEMICAL ENGINEERING JOURNAL, 2000, 79 (02) :123-131
[14]   Influence of time on crystal attrition in a stirred vessel [J].
Mazzarotta, B ;
DiCave, S ;
Bonifazi, G .
AICHE JOURNAL, 1996, 42 (12) :3554-3558
[15]   ATTRITION OF PARTICULATE SOLIDS UNDER SHEAR [J].
NEIL, AU ;
BRIDGWATER, J .
POWDER TECHNOLOGY, 1994, 80 (03) :207-219
[16]  
Newitt D.M., 1958, TRANSACTION I CHEM E, V36, P422
[17]   THE STICKY ISSUES OF DRYING [J].
PAPADAKIS, SE ;
BAHU, RE .
DRYING TECHNOLOGY, 1992, 10 (04) :817-837
[18]  
PEARSON JMK, 1998, P WORLD C PART TECHN
[19]   Scale-down of a high-shear pelletisation process: Flow profile and growth kinetics [J].
Ramaker, JS ;
Jelgersma, MA ;
Vonk, P ;
Kossen, NWF .
INTERNATIONAL JOURNAL OF PHARMACEUTICS, 1998, 166 (01) :89-97
[20]   Scaling up of the fluidized bed granulation process [J].
Rambali, B ;
Baert, L ;
Massart, DL .
INTERNATIONAL JOURNAL OF PHARMACEUTICS, 2003, 252 (1-2) :197-206