Inter-laminar delamination analyses of Spar Wingskin Joints made with flat FRP composite laminates

3D Finite Element Analyses have been carried out for Spar Wingskin Joints made with laminated Graphite Fibre Reinforced Plastic composites subjected to uniformly distributed transverse load. The delamination has been pre-embedded at the most likely location, i.e. in resin layer between the top and next ply of the fibre reinforced plastic laminated wingskin and near the spar overlap end. Multi-Point Constraint finite elements have been made use of at the vicinity of the delamination fronts. This helps in simulating the growth of the embedded delamination at both ends. The inter-laminar peel and shear stresses responsible for causing delamination damage have been evaluated. Strain energy release rate components corresponding to the Mode I (opening), Mode II (sliding) and Mode III (tearing) of delamination are determined using the principle of Virtual Crack Closure Technique. These are seen to be different and non-self-similar at the two fronts of the embedded delamination. Mode I Strain energy release rate (G(1)) primarily governs the process of delamination propagation. (C) 2016 Elsevier Ltd. All rights reserved.