Assessment of debonding in sandwich CF/EP composite beams using A0 Lamb wave at low frequency

被引：82

作者：

Mustapha, Samir ^{[1
]}

Ye, Lin ^{[1
]}

Wang, Dong ^{[1
]}

Lu, Ye ^{[1
]}

机构：

[1] Univ Sydney, LSMS, CAMT, Sch Aerosp Mech & Mechatron Engn, Sydney, NSW 2006, Australia

来源：

COMPOSITE STRUCTURES | 2011年 / 93卷 / 02期

关键词：

Debonding; Sandwich CF/EP composite beams; Lamb waves; PZT; FEA; VELOCITY IMPACT DAMAGE; ACTIVE SENSOR NETWORK; NONDESTRUCTIVE INSPECTION; IDENTIFICATION; DELAMINATION; PANELS;

D O I：

10.1016/j.compstruct.2010.08.032

中图分类号：

O3 [力学];

学科分类号：

08 ; 0801 ;

摘要：

The aim of this study is to quantitatively assess debonding in sandwich CF/EP composite structures with a honeycomb core using acoustic waves activated and captured by surface-mounted Pit elements For experimental investigation debonding was introduced at different locations in sandwich CF/EP composite beams The fundamental anti-symmetric A(0) Lamb mode was excited at a low frequency The transmitted and reflected wave signals in both surface panels were captured by Pit elements after interacting with the debonding damage and specimen boundaries Aided by finite element analysis (FEA) the differences in wave propagation characteristics in sandwich composite beams and composite laminate (e g skin panel only) were investigated The debonding location was assessed using the time-of-flight (ToF) of damage-reflected waves and the severity of debonding was evaluated using both the magnitude of the reflected wave signal and the delay in the ToF of Lamb wave signals Good correlation between the experimental and FEA simulation results was observed The results demonstrate the effectiveness of Lamb waves activated and captured by surface-mounted Pit elements on either surface of sandwich composite structures in assessing debonding (C) 2010 Elsevier Ltd All rights reserved

引用

页码：483 / 491

页数：9

共 21 条

[1] Piezoelectric transducer arrangement for the inspection of large composite structures [J].

Diamanti, K. ;

Soutis, C. ;

Hodgkinson, J. M. .

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2007, 38 (04) :1121-1130

[2] Non-destructive inspection of sandwich and repaired composite laminated structures [J].

Diamanti, K ;

Soutis, C ;

Hodgkinson, JM .

COMPOSITES SCIENCE AND TECHNOLOGY, 2005, 65 (13) :2059-2067

[3] Lamb waves for the non-destructive inspection of monolithic and sandwich composite beams [J].

Diamanti, K ;

Soutis, C ;

Hodgkinson, JM .

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2005, 36 (02) :189-195

[4] Detection of low-velocity impact damage in composite plates using lamb waves [J].

Diamanti, K ;

Hodgkinson, JM ;

Soutis, C .

STRUCTURAL HEALTH MONITORING-AN INTERNATIONAL JOURNAL, 2004, 3 (01) :33-41

[5]

Fatt MSH, 2001, COMPOS STRUCT, V52, P335

[6] Delamination detection in smart composite beams using Lamb waves [J].

Ip, KH ;

Mai, YW .

SMART MATERIALS AND STRUCTURES, 2004, 13 (03) :544-551

[7] Residual stresses in structures reinforced with adhesively bonded straps designed to retard fatigue crack growth [J].

Liljedahl, C. D. M. ;

Fitzpatrick, M. E. ;

Edwards, L. .

COMPOSITE STRUCTURES, 2008, 86 (04) :344-355

[8] Diagnostic Lamb waves in an integrated piezoelectric sensor/actuator plate: analytical and experimental studies [J].

Lin, X ;

Yuan, FG .

SMART MATERIALS & STRUCTURES, 2001, 10 (05) :907-913

[9] Prediction of flange debonding in composite stiffened panels using an analytical crack tip element-based methodology [J].

Mikulik, Zoltan ;

Kelly, Donald W. ;

Prusty, B. Gangadhara ;

Thomson, Rodney S. .

COMPOSITE STRUCTURES, 2008, 85 (03) :233-244

[10] A quantitative identification approach for delamination in laminated composite beams using digital damage fingerprints (DDFs) [J].

Pan, Nan ;

Su, Zhongqing ;

Ye, Lin ;

Zhou, Li-Min ;

Lu, Ye .

COMPOSITE STRUCTURES, 2006, 75 (1-4) :559-570

← 1 2 3 →