Photocatalytic degradation of steroid hormone micropollutants by TiO2-coated polyethersulfone membranes in a continuous flow-through process

A polyethersulfone-titanium dioxide membrane is demonstrated to be effective at micropollutant removal during the photocatalytic degradation of steroid hormones in a flow-through photocatalytic membrane reactor under UV light at environmentally relevant concentrations. Micropollutants in the aquatic environment pose a high risk to both environmental and human health. The photocatalytic degradation of steroid hormones in a flow-through photocatalytic membrane reactor under UV light (365 nm) at environmentally relevant concentrations (50 ng l(-1) to 1 mg l(-1)) was examined using a polyethersulfone-titanium dioxide (PES-TiO2) membrane. The TiO2 nanoparticles (10-30 nm) were immobilized both on the surface and in the nanopores (220 nm) of the membrane. Water quality and operational parameters were evaluated to elucidate the limiting factors in the degradation of steroid hormones. Flow through the photocatalytic membrane increased contact between the micropollutants and center dot OH in the pores. Notably, 80% of both oestradiol and oestrone was removed from a 200 ng l(-1) feed (at 25 mW cm(-)(2) and 300 l m(-)(2) h(-1)). Progesterone and testosterone removal was lower at 44% and 33%, respectively. Increasing the oestradiol concentration to 1 mg l(-1) resulted in 20% removal, whereas with a 100 ng l(-1) solution, a maximum removal of 94% was achieved at 44 mW cm(-)(2) and 60 l m(-)(2) h(-1). The effectiveness of the relatively well-known PES-TiO2 membrane for micropollutant removal has been demonstrated; this effectiveness is due to the nanoscale size of the membrane, which provides a high surface area and facilitates close contact of the radicals with the very small (0.8 nm) micropollutant at an extremely low, environmentally relevant concentration (100 ng l(-1)).