Dynamic fragmentation and spheroidization of α phase grains during hot deformation of Ti-6Al-4V alloy

被引：9
作者：
Motyka, Maciej [1 ]
Sieniawski, Jan [1 ]
Ziaja, Waldemar [1 ]
Mroczka, Malwina [1 ]
Brylinski, Mateusz [1 ]
机构：
[1] Rzeszow Univ Technol, Fac Mech Engn & Aeronaut, Dept Mat Sci, Al Powstancow Warszawy 12, PL-35959 Rzeszow, Poland
来源：
INTERNATIONAL JOURNAL OF MATERIALS RESEARCH | 2018年 / 109卷 / 08期
关键词：
Two-phase titanium alloys; Hot deformation; Microstructure; Fragmentation and spheroidization of alpha phase grains; Superplasticity; LAMELLAR MICROSTRUCTURE; STATIC GLOBULARIZATION; MECHANISMS; SUPERPLASTICITY; KINETICS; WORKING;
D O I：
10.3139/146.111660
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
Development of mechanical properties of titanium alloys is usually achieved by the control of their microstructure (globular, lamellar, bimodal). Dynamic fragmentation and spheroidization of elongated alpha phase grains, formed from martensite laths, in the microstructure of Ti-6Al-4V alloy are considered in the paper. The effects of alpha phase grain spheroidization was evaluated in tensile tests over a temperature range of 800-900 degrees C and strain rate range of 10(-3) - 10(-2) s(-1). Completed spheroidization of elongated alpha phase grains and subsequent growth of equiaxed grains for all deformation modes were found. A low value of apparent activation energy for deformation was calculated - suggesting grain boundary sliding was the main deformation mechanism. The results showed good correlation with the kinetic rate equation based on the Zener-Hollomon parameter.
引用
收藏
页码：685 / 693
页数：9
相关论文
共 23 条
  • [1] On the mechanisms of superplasticity in Ti-6Al-4V
    Alabort, E.
    Kontis, P.
    Barba, D.
    Dragnevski, K.
    Reed, R. C.
    [J]. ACTA MATERIALIA, 2016, 105 : 449 - 463
  • [2] Ashby M.F., 1982, DEFORMATION MECH MAP
  • [3] THE INFLUENCE OF INTERSTITIAL IMPURITIES ON TRUE GRAIN-BOUNDARY SLIDING OF TITANIUM IN COARSE-GRAINED AND SUBMICROCRYSTALLINE STATES
    Dudarev, E. F.
    Golosov, E. V.
    Kolobov, Yu R.
    Pochivalova, G. P.
    Bakach, G. P.
    Torganchuk, V. I.
    [J]. RUSSIAN PHYSICS JOURNAL, 2011, 53 (10) : 1016 - 1023
  • [4] SEM/EBSD Analysis on Globularization Behavior of Lamellar Microstructure in Ti-6Al-4V During Hot Deformation and Annealing
    Ito, Yoshinori
    Murakami, Shogo
    Tsuji, Nobuhiro
    [J]. METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2017, 48A (09): : 4237 - 4246
  • [5] Jonas J.J., 1969, Metall Rev, V14, P1, DOI [10.1179/095066069790138056, DOI 10.1179/095066069790138056]
  • [6] Microstructure evolution during warm working of Ti-6Al-4V with a colony-α microstructure
    Mironov, S.
    Murzinova, M.
    Zherebtsov, S.
    Salishchev, G. A.
    Semiatin, S. L.
    [J]. ACTA MATERIALIA, 2009, 57 (08) : 2470 - 2481
  • [7] MICROSTRUCTURAL CHARACTERIZATION OF QUENCHED AND PLASTICALLY DEFORMED TWO-PILASE α plus β TITANIUM ALLOYS
    Motyka, M.
    Sieniawski, J.
    Ziaja, W.
    Mrowka-Nowotnik, G.
    [J]. ARCHIVES OF METALLURGY AND MATERIALS, 2015, 60 (03) : 2033 - 2037
  • [8] Motyka M., 2015, THERMOMECHANICAL PRO
  • [9] Motyka M., 2014, COMPREHENSIVE MAT PR, V2
  • [10] Microstructural aspects of superplasticity in Ti-6Al-4V alloy
    Motyka, Maciej
    Sieniawski, Jan
    Ziaja, Waldemar
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2014, 599 : 57 - 63
123