Analysis of Die Angle in Deep Drawing Process Using FEM

被引：1

作者：

Choubey, Ajay Kumar ^{[1
,2
]}

Agnihotri, Geeta ^{[1
]}

Sasikumar, C. ^{[1
]}

Singh, Monika

机构：

[1] Maulana Azad Natl Inst Technol, Bhopal 462003, India

[2] MANIT, Dept MSME, Bhopal 462003, India

来源：

MATERIALS TODAY-PROCEEDINGS | 2017年 / 4卷 / 02期

关键词：

ANSYS; Deep Drawing; FEM; Stainless Steel;

D O I：

暂无

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

In the deep drawing process, maximization of efficiency and minimization of errors is the very important parameters. Deep drawing technique is averycomplex, costly and widely used manufacturing process, in many industrial applications. In this work, ANSYS simulation software used for gain accurate and critical understanding of deep drawing parameters. The results were showing that, the compressive stresses are minimum at 22 degrees die angle at 3.5 mm/sec optimized punch speed. (C) 2017 Published by Elsevier Ltd.

引用

页码：2511 / 2515

页数：5

共 7 条

[1] Finite element modeling and experimental results of brass elliptic cups using a new deep drawing process through conical dies
Dhaiban, Abdullah A.
Soliman, M. -Emad S.
El-Sebaie, M. G.
[J]. JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2014, 214 (04) : 828 - 838
[2] Hassan M. A., P WORLD C ENG, VII
[3] Mangshetty, 2012, INT J ENG RES DEV, V4, P23
[4] Mohan Krishna K., 2014, INT REFEREED J ENG S, V3, P24
[5] Pop Alin, 2015, NONCONVENTIONAL TECH, P46
[6] Reddy G. Chandramohan, 2013, ADV MAT MANUFACTURIN, V3, P381
[7] Talapatra Animesh, 2014, INT J CHEMTECH RES, V6, P2014

← 1 →