Scratch hardness and chipping of dental ceramics under different environments

Objective. The goal of this program was to identify promising environments that could efficiently minimize machining-induced damage of dental materials. Methods. Single point abrasion (SPA) scratch testing was used on five materials to determine the scratch hardness and amount of edge chipping as functions of chemical environment, including air, water, saline and glycerol solutions. Limited testing was also done under additional environments expected to promote chemomachining effects via crack growth promotion or debris removal. A conical diamond indenter and a conventional tungsten carbide machining tool were used in the scratch tests. One-way ANOVA analysis was used to determine statistical differences among the variables. Results. There was a consistent trend across materials that the water and saline yielded the lowest values of scratch hardness, air the next lowest, and the tests performed in glycerol yielded the highest hardness values. The measured hardness values using the conical diamond tool in the glycerol environments were about twice the hardness values measured under water and saline solutions. Environmental effects on chipping were minimal, but a linear relationship between load and per cent chipping was determined for the WC tool within the 10-50 N test range. The choice of scratch tool strongly affected scratch hardness and chipping tendency. Significance. The chemical environment had an effect on machining characteristics, but the effects were more dependent on. tool interactions rather than material specific properties. As a result, it may not be possible to utilize a particular single environment to substantially improve the damage response of dental materials to machining operations. Improvements in damage resistance can be environmentally obtained, but only for shallow cuts (finishing operations). 2003 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.