New design total knee arthroplasty shows medial pivoting movement under weight-bearing conditions

被引:18
作者
Bragonzoni, Laura [2 ]
Muccioli, Giulio Maria Marcheggiani [1 ,2 ]
Bontempi, Marco [2 ]
di Sarsina, Tommaso Roberti [1 ]
Cardinale, Umberto [2 ]
Alesi, Domenico [1 ]
Iacono, Francesco [3 ]
Neri, Maria Pia [1 ]
Zaffagnini, Stefano [1 ]
机构
[1] Ist Ortoped Rizzoli, IRCCS, Orthopaed & Traumatol Clin 2, Lab Biomeccan, Via Barbiano 1-10, I-40136 Bologna, Italy
[2] Univ Bologna, Bologna, Italy
[3] Humanitas Clin Inst, Prosthet Surg & Articular Biol Reconstruct, Milan, Italy
关键词
Dynamic radiostereometric analysis; Total knee arthroplasty; In vivo knee kinematics; IN-VIVO KINEMATICS; MOBILE-BEARING; LIVING KNEE; FLEXION; TKA; REPLACEMENT; STABILITY; GEOMETRY;
D O I
10.1007/s00167-018-5243-5
中图分类号
R826.8 [整形外科学]; R782.2 [口腔颌面部整形外科学]; R726.2 [小儿整形外科学]; R62 [整形外科学(修复外科学)];
学科分类号
摘要
PurposeTo assess, using model-based dynamic radiostereometric analysis (RSA), the biomechanical behaviour of a new design posterior-stabilized (PS) fixed-bearing (FB) total knee arthroplasty (TKA) in vivo while patients performing two common motor tasks. The hypothesis was that model-based dynamic RSA is able to detect different behaviour of the implant under weight-bearing and non-weight-bearing conditions.MethodsA cohort of 15 non-consecutive patients was evaluated by dynamic RSA 9months after TKA implantation. The mean age of patients was 73.4 (65-72) years. The kinematic evaluations were performed using an RSA device (BI-STAND DRX 2) developed in our Institute. The patients were asked to perform two active motor tasks: sit-to-stand in weight-bearing condition; range of motion (ROM) while sitting on the chair. The motion parameters were evaluated using the Grood and Suntay decomposition and the low-point kinematics methods.ResultsThe dynamic RSA evaluation showed a significant difference (p<0.05) between the biomechanical behaviour of the prosthesis during the two motor tasks. When subjected to the patient weight (in the sit-to-stand) the low point of the medial compartment had a shorter motion (5.70.2mm) than the lateral (11.00.2mm). This realizes a medial pivot motion as in the normal knee. In the ROM task, where the patient had no weight on the prosthesis, this difference was not present: the medial compartment had a displacement of 12.7 +/- 0.2mm, while the lateral had 17.3 +/- 0.2mm.Conclusions Model-based RSA proved to be an effective tool for the evaluation of TKA biomechanics. In particular, it was able to determine that the fixed-bearing posterior-stabilized TKA design evaluated in this study showed a medial pivoting movement under weight-bearing conditions that was not present when load was not applied. Under loading conditions what drives the pattern of movement is the prosthetic design itself. By the systematic use of this study protocol future comparisons among different implants could be performed, thus contributing significantly to the improvement of TKA design.Level of evidence IV.
引用
收藏
页码:1049 / 1056
页数:8
相关论文
共 50 条
[31]   Efficacy of post-operative partial weight-bearing after total knee arthroplasty - a prospective observational trial [J].
Anderson, Philip Mark ;
Heinz, Tizian ;
Scholmann, Elena ;
Eidmann, Annette ;
Arnholdt, Jorg ;
Rudert, Maximilian ;
Holzapfel, Boris Michael ;
Stratos, Ioannis .
INTERNATIONAL ORTHOPAEDICS, 2023, 47 (09) :2189-2195
[32]   Knee manipulation under anaesthetic following total knee arthroplasty A MATCHED COHORT DESIGN [J].
Dzaja, I. ;
Vasarhelyi, E. M. ;
Lanting, B. A. ;
Naudie, D. D. ;
Howard, J. L. ;
Somerville, L. ;
McCalden, R. W. ;
MacDonald, S. J. .
BONE & JOINT JOURNAL, 2015, 97B (12) :1640-1644
[33]   Significant Effect of the Posterior Tibial Slope on the Weight-Bearing, Midflexion In Vivo Kinematics After Cruciate-Retaining Total Knee Arthroplasty [J].
Fujimoto, Eisaku ;
Sasashige, Yoshiaki ;
Tomita, Tetsuya ;
Iwamoto, Keiji ;
Masuda, Yasuji ;
Hisatome, Takashi .
JOURNAL OF ARTHROPLASTY, 2014, 29 (12) :2324-2330
[34]   Sit-to-Stand Weight-Bearing Symmetry Performance in Total Knee Arthroplasty Recovery Curves, Correlates, and Predictive Validity With Gait Speed [J].
Pua, Yong-Hao ;
Tan, John Wei-Ming ;
Poon, Cheryl Lian-Li ;
Chew, Eleanor Shu-Xian ;
Seah, Felicia Jie-Ting ;
Thumboo, Julian ;
Yeo, Seng-Jin ;
Woon, Ee-Lin ;
Clark, Ross Allan .
AMERICAN JOURNAL OF PHYSICAL MEDICINE & REHABILITATION, 2022, 101 (07) :666-673
[35]   Weight-bearing line at the ankle joint level shifted laterally after total knee arthroplasty for varus knee osteoarthritis: Evaluation of the hip-to-calcaneus line [J].
Kikuchi, Naoya ;
Kanamori, Akihiro ;
Okuno, Kosuke ;
Yamazaki, Masashi .
ORTHOPAEDICS & TRAUMATOLOGY-SURGERY & RESEARCH, 2024, 110 (02)
[36]   Design of an Advanced Bearing System for Total Knee Arthroplasty [J].
Morrison, Mark L. ;
Jani, Shilesh ;
Parikh, Amit .
LUBRICANTS, 2015, 3 (02) :475-492
[37]   Influence of Gap Balance on the Sagittal Movement of a Specific Mobile Bearing Floating Platform Design in Total Knee Arthroplasty [J].
Lee, Dae-Hee ;
Lee, Dong-Ki ;
Shin, Young-Soo ;
Han, Seung-Beom .
JOURNAL OF ARTHROPLASTY, 2013, 28 (10) :1717-1721
[38]   Combined magnetic resonance imaging approach for the assessment of in vivo knee joint kinematics under full weight-bearing conditions [J].
Al Hares, Ghaith ;
Eschweiler, Joerg ;
Radermacher, Klaus .
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART H-JOURNAL OF ENGINEERING IN MEDICINE, 2015, 229 (06) :439-451
[39]   Weight Bearing Activities change the Pivot Position after Total Knee Arthroplasty [J].
Moewis, Philippe ;
Hommel, Hagen ;
Trepczynski, Adam ;
Krahl, Leonie ;
von Roth, Philipp ;
Duda, Georg N. .
SCIENTIFIC REPORTS, 2019, 9 (1)
[40]   In vivo kinematic comparison of posterior cruciate-retaining and posterior stabilized total knee arthroplasties under passive and weight-bearing conditions [J].
Yoshiya, S ;
Matsui, N ;
Komistek, RD ;
Dennis, DA ;
Mahfouz, M ;
Kurosaka, M .
JOURNAL OF ARTHROPLASTY, 2005, 20 (06) :777-783