Graphite intercalated polymer coatings on stainless steel

The use of graphite modified polymer films has been investigated, on stainless steel. Polythiophene and polypyrrole films have been synthesized electrochemically on stainless steel, and then very thin graphite layers were realized on polymer films. Since the graphite layer is not applicable as a top coat, polymeric top films were also electrosynthesized on graphite layers. Following this procedure, polypyrrole-graphite-polypyrrole and polythiophene-graphite-polythiophene coatings have been obtained on stainless steel. The corrosion behaviours of coated samples have been investigated in 0.1 M H2SO4 Solution, by means of electrochemical impedance spectroscopy (EIS) and anodic polarization curves. The intercalation of graphite layer altered the performance and properties of coatings significantly. Especially, polypyrrole coating system was found to exhibit almost an excellent coating behaviour that hindered the attack of corrosive environment within 96 h exposure time. The EIS results of polypyrrole coating system were indicating to almost a perfect capacitive behaviour that the response was reflecting capacitive behaviour in a wide frequency region. This property was also examined with successive cyclic voltammograms in a potential range between 0. 10 and 0.40 V (vs. Ag/AgCl). The charge densities involved in oxidation and reduction regions were determined for successive cycles and it was shown that coated sample was able to exhibit charge-discharge (i.e. oxidation and reduction) behaviour successfully, without any degradation. (c) 2007 Elsevier B.V. All rights reserved.