Investigation of unsteady flow field in a vaned diffuser of a transonic centrifugal compressor

被引:32
|
作者
Ibaraki, Seiichi [1 ]
Matsuo, Tetsuya [1 ]
Yokoyama, Takao [1 ]
机构
[1] Mitsubishi Heavy Ind Co Ltd, Nagasaki Res & Dev Ctr, Nagasaki 8508610, Japan
来源
关键词
D O I
10.1115/1.2720505
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
Transonic centrifugal compressors are used with high-load turbochargers and turboshaft engines. These compressors usually have a vaned diffuser to increase the efficiency and the pressure ratio. To improve the performance of such a centrifugal compressor, it is required to optimize not only the impeller but also the diffuser However the flow field of the diffuser is quite complex and unsteady because of the impeller located upstream. Although some research on vaned diffusers has been published, the diffuser flow is strongly dependent on the particular impeller exit flow, and some of the flow physics remain to be elucidated. In the research reported here, detailed flow measurements within a vaned diffuser were conducted using a particle image velocimetery (PIV). The vaned diffuser was designed with high subsonic inlet conditions marked by an inlet Mach number of 0.95 for the transonic compressor As a result, a complex three-dimensional flow with distortion between the shroud and the hub was observed. Also, unsteady flow accompanying the inflow of the impeller wake was confirmed. Steady computational flow analysis was performed and compared with the experimental results.
引用
收藏
页码:686 / 693
页数:8
相关论文
共 50 条
  • [21] NUMERICAL EVALUATION OF THE UNSTEADY FLOW IN A CENTRIFUGAL COMPRESSOR WITH VANED DIFFUSER VIA URANS APPROACH
    Zamiri, Ali
    Lee, Byung Ju
    Chung, Jin Taek
    PROCEEDINGS OF THE ASME TURBO EXPO: TURBINE TECHNICAL CONFERENCE AND EXPOSITION, 2016, VOL 2D, 2016,
  • [22] A numerical investigation of the effect of vaned diffuser water cooling on the internal flow field of a centrifugal compressor
    Wang, Yu
    Chen, Hua
    Li, Chao
    Ma, Chao
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY, 2024, 238 (02) : 232 - 240
  • [23] An Investigation of Stall Inception in Centrifugal Compressor Vaned Diffuser
    Everitt, Jonathan N.
    Spakovszky, Zoltan S.
    JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 2013, 135 (01):
  • [24] INVESTIGATION OF UNSTEADY IMPELLER-DIFFUSER INTERACTION IN A TRANSONIC CENTRIFUGAL COMPRESSOR STAGE
    Liu, Yangwei
    Liu, Baojie
    Lu, Lipeng
    PROCEEDINGS OF THE ASME TURBO EXPO 2010: TURBOMACHINERY: AXIAL FLOW FAN AND COMPRESSOR AERODYNAMICS DESIGN METHODS, AND CFD MODELING FOR TURBOMACHINERY, VOL 7, PTS A-C, 2010, : 1961 - 1971
  • [25] INVESTIGATION OF SURGE IN A TRANSONIC CENTRIFUGAL COMPRESSOR WITH VANED DIFFUSER: PART 1-SURGE SIGNATURE
    Lou, Fangyuan
    Harrison, Herbert M.
    Key, Nicole L.
    PROCEEDINGS OF ASME TURBO EXPO 2022: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, GT2022, VOL 10D, 2022,
  • [26] Investigation of Surge in a Transonic Centrifugal Compressor With Vaned Diffuser-Part I: Surge Signature
    Lou, Fangyuan
    Harrison, Herbert M. M.
    Key, Nicole L. L.
    JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 2023, 145 (05):
  • [27] UNSTEADY PRE-STALL BEHAVIOR IN A CENTRIFUGAL COMPRESSOR WITH VANED DIFFUSER
    Suzuki, Yutaro
    Fujisawa, Nobumichi
    Ohta, Yutaka
    PROCEEDINGS OF ASME TURBO EXPO 2023: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, GT2023, VOL 13D, 2023,
  • [28] Unsteady Pre-Stall Behavior in a Centrifugal Compressor With Vaned Diffuser
    Suzuki, Yutaro
    Fujisawa, Nobumichi
    Ohta, Yutaka
    JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 2024, 146 (04):
  • [29] Adaptive vaned diffuser for centrifugal compressor
    Ferrara, G.
    Ferrari, L.
    Baldassarre, L.
    Proceedings of the ASME Turbo Expo 2005, Vol 6, Pts A and B, 2005, : 927 - 934
  • [30] SCALE ADAPTIVE SIMULATION OF TRANSIENT BEHAVIOR IN A TRANSONIC CENTRIFUGAL COMPRESSOR WITH A VANED DIFFUSER
    Zamiri, Ali
    Chung, Jin Taek
    PROCEEDINGS OF THE ASME TURBO EXPO: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, 2018, VOL 2C, 2018,