EXPERIMENTAL MEASUREMENTS AND FLOW VISUALIZATION OF WATER CAVITATION THROUGH A NOZZLE

被引:0
|
作者
Wilms, Jeffrey [1 ]
Beck, Terry [1 ]
Sorensen, Christopher M. [2 ]
Hosni, Mohammad H. [1 ]
Eckels, Steven J. [1 ]
Tomasi, Don [3 ]
机构
[1] Kansas State Univ, Mech & Nucl Engn Dept, Manhattan, KS 66506 USA
[2] Kansas State Univ, Dept Phys, Manhattan, KS 66506 USA
[3] D&V Consulting LLC, Stevensville, MI USA
来源
PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, 2014, VOL 7 | 2015年
关键词
Cavitation; Flow visualization; Vapor; Bubbles; Velocity;
D O I
暂无
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
typical refrigeration loop is composed of an evaporator, compressor, condenser, and an expansion valve. There are many possible refrigerants that can be used, but the physical properties. of water make it ineffective in the traditional refrigeration loop. But if water could be used it would have many advantages as it is abundant, cheap, and is safe for the environment. As part of development of a new refrigeration loop using water, flow visualization and cavitation of water through nozzles are being investigated. Cavitation is generally defined as creating vapor from liquid, not through adding heat, but by decreasing the pressure. In a converging/diverging nozzle as the cross sectional area is constricted the velocity of the flow will increase, decreasing the pressure. Therefore, by flowing water through the nozzle it will cavitate. Transforming liquid into gas requires a certain amount of energy, defined as the latent heat. When a liquid is turned to vapor by an increase in the temperature the latent heat is provided by the heat transfer to the system. As no energy is being added in the nozzle to cause the cavitation, the heat to create the vapor comes from the liquid, effectively causes a temperature drop. This article presents results for the flow visualization of the water cavitating as it goes through the nozzle. Under different flow conditions and nozzle geometries the cavitation manifested itself in different formations. When gasses were entrained in the water they formed bubbles, creating a nucleation site and moving through the nozzle, called travelling bubble cavitation. In venturi nozzles the cavitation nucleated off of the wall, formiong attached wall cavitation. When water flowed out of an orifice, a turbulent water jet was formed which caused vapor to form around it, causing shear cavitation. When the water was rotated prior to the throat of an orifice, the orifice jet expanded radially and formed swirl cavitation.
引用
收藏
页数:10
相关论文
共 50 条
  • [31] Study of cavitation phenomenon using different fuels in a transparent nozzle by hydraulic characterization and visualization
    Payri, R.
    Salvador, F. J.
    Gimeno, J.
    Venegas, O.
    EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2013, 44 : 235 - 244
  • [32] A flow visualization study on the movements of solid particles propelled by a collapsing cavitation bubble
    Soh, WK
    Willis, B
    EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2003, 27 (05) : 537 - 544
  • [33] Relationships and Mechanisms of Sand Grain Promotion on Nozzle Cavitation Flow Evolution: A Numerical Simulation Investigation
    Han Xiangdong
    Xiao Jingping
    Yu Fangyan
    Zhao Weiguo
    JOURNAL OF THERMAL SCIENCE, 2022, 31 (06) : 2385 - 2410
  • [34] Numerical investigations of cavitation in a nozzle on the LNG fuel internal flow characteristics
    Xiao, Min
    Zhang, Wei
    Shi, Jiajun
    PROCEEDINGS OF THE FIRST INTERNATIONAL CONFERENCE ON INFORMATION SCIENCES, MACHINERY, MATERIALS AND ENERGY (ICISMME 2015), 2015, 126 : 1782 - 1786
  • [35] Experimental procedures and cavitation mechanisms in tensiometer measurements
    Tarantino A.
    Mongiovì L.
    Geotechnical and Geological Engineering, 2001, 19 (3-4) : 189 - 210
  • [36] Flow visualization and characteristics of a coaxial jet with a tabbed annular nozzle
    Kiwata, Takahiro
    Ishii, Takashi
    Kimura, Shigeo
    Okajima, Atsushi
    Miyazaki, Katsuya
    JSME INTERNATIONAL JOURNAL SERIES B-FLUIDS AND THERMAL ENGINEERING, 2006, 49 (04) : 906 - 913
  • [37] Experimental measurements of the cavitating flow after horizontal water entry
    Thang Tat Nguyen
    Duong Ngoc Hai
    Nguyen Quang Thai
    Truong Thi Phuong
    FLUID DYNAMICS RESEARCH, 2017, 49 (05)
  • [38] Investigation of submerged waterjet cavitation through surface property and flow information in ambient water
    Kang, Can
    Liu, Haixia
    Zhang, Tao
    Li, Qing
    APPLIED SURFACE SCIENCE, 2017, 425 : 915 - 922
  • [39] Research on the Effects of Silt Mean Diameters and Silt Concentrations on the Cavitation Flow in a Nozzle
    Zhao W.
    Han X.
    Sheng J.
    Pan X.
    1600, Shanghai Jiaotong University (51): : 1399 - 1404
  • [40] The Study on Cavitation Phenomena of Zoom Nozzle Based on Orthogonal Experimental and Spraying Mechanics
    Zhao, XinZe
    Yan, HouLin
    Yang, ZhenXing
    XianYu, WenLing
    RESEARCH ON MATERIAL ENGINEERING AND MANUFACTURING ENGINEERING, 2014, 468 : 119 - +