Wind tunnel evaluation of a wedge-shaped aeolian sediment trap

被引：116

作者：

Nickling, WG ^{[1
]}

Neuman, CM ^{[1
]}

机构：

[1] TRENT UNIV, DEPT GEOG, PETERBOROUGH, ON K9J 7B8, CANADA

来源：

GEOMORPHOLOGY | 1997年 / 18卷 / 3-4期

关键词：

sand; sediment flux; erosion; deflation;

D O I：

10.1016/S0169-555X(96)00040-2

中图分类号：

P9 [自然地理学];

学科分类号：

0705 ; 070501 ;

摘要：

A detailed set of tests in a wind tunnel investigated the characteristics of flow and sampling efficiency of a low cost sediment trap that can be used in wind tunnels and field applications. The trap is constructed of thin sheet aluminum and has a wedge shape (32 degrees internal inlet angle with a 20 x 500 mm rectangular inlet orifice that extends 40 mm beyond the wedge form. Relatively unimpeded airflow through the trap is achieved by the large exit area (130 x 500 mm) which is covered with fine, stainless steel mesh (62.5 mu m openings, 60% porosity), and collected all but the finer (silt) sediment sizes. Despite its angular shape, the trap has good characteristics of flow and a very high sampling efficiency (> 90%) over a wide range of wind velocities because of its near isokinetic characteristics of flow. Results also indicate that this trap, and others that have wide side profiles, are very sensitive to incident wind angle. Incident angles > 5 degrees significantly reduce the sampling efficiency and promote scour around the trap inlet.

引用

页码：333 / 345

页数：13

共 35 条

[1]

Anderson R. S., 1991, ACTA MECHANICA S, V1, P21, DOI DOI 10.1007/978-3-7091-6706-9_

[2]

[Anonymous], 1985, P INT WORKSHOP PHYS

[3]

[Anonymous], 1991, AEOLIAN GRAIN TRANSP, DOI [DOI 10.1007/978-3-7091-6706-9_6, DOI 10.1007/978-3-7091-6706-9_]

[4]

BAGNOLD RA, 1941, PHYSICS BLOWN SAND D

[5]

Belly P.Y., 1964, 1 US ARM CORPS ENG C

[6]

CHEPIL WS, 1959, P SOIL SCI SOC AM, V23, P422

[7] THE LAW OF THE WAKE IN THE TURBULENT BOUNDARY LAYER [J].

COLES, D .

JOURNAL OF FLUID MECHANICS, 1956, 1 (02) :191-226

[8]

FRYREAR DW, 1986, J SOIL WATER CONSERV, V41, P117

[9]

Gerety, 1985, P INT WORKSHOP PHYSI, V8, P271

[10]

GILLETTE DA, 1977, T ASAE, V20, P890

← 1 2 3 4 →