Diffusion correlation effects of molybdenum and silicon in molybdenum disilicide

被引:6
作者
Belova, Irina V. [1 ]
Mehrer, Helmut [2 ]
Murch, Graeme E. [1 ]
机构
[1] Univ Newcastle, Univ Ctr Mass & Thermal Transport Engn Mat, Sch Engn, Callaghan, NSW 2308, Australia
[2] Univ Munster, Inst Mat Phys, D-48149 Munster, Germany
关键词
molybdenum disilicide; self-diffusion; diffusion correlation factors; diffusion anisotropy; sublattice vacancy mechanism; Monte Carlo simulations; TRACER DIFFUSION; COEFFICIENTS; SIMULATION;
D O I
10.1080/14786435.2011.590460
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Diffusion data for both principal directions of silicon and molybdenum as well as germanium are briefly summarised. Analysis is performed of the defect formation energies (available from previous ab initio calculations and experimental measurements) for diffusion mechanisms via home and foreign sublattices. The home sublattice mechanism is shown to be the preferred one for both silicon and molybdenum. Tracer correlation factors for silicon and molybdenum diffusion via sublattice vacancies in the respective sublattices of the tetragonal C11(b) structure of molybdenum disilicide are calculated by a direct Monte Carlo simulation technique. Correlation factors for Si diffusion on its sublattice are compared with literature values that were calculated using a more complicated Monte Carlo method based on the matrix approach. It is shown that there is no need for this complicated approach and that the direct Monte Carlo simulation technique gives highly accurate correlation factors. Correlation factors and anisotropy ratios of vacancy-mediated diffusion in both sublattices are deduced and compared with experimental data. Tracer correlation in the tetragonal direction is shown to contribute 0.40 eV (i.e. over 55%) of the migration energy of the corresponding Si diffusivity. Two possible jump rates for Si diffusion are separately estimated. Mo diffusion correlation factors are calculated using the direct Monte Carlo technique. A comparison with experiment is made and the ratio of two possible jump rates is also estimated.
引用
收藏
页码:3727 / 3743
页数:17
相关论文
共 28 条
[1]  
Allnatt AR., 1993, atomic transport in solids
[2]  
[Anonymous], INTERMETALLIC COMPOU
[3]  
[Anonymous], DIFFUS FUNDAM
[4]  
[Anonymous], THESIS U MUENSTER GE
[5]  
[Anonymous], INTERSTITIAL COMPOUN
[6]   Atomistic potentials for the molybdenum-silicon system [J].
Baskes, MI .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1999, 261 (1-2) :165-168
[7]   Bridging different length and time scales in diffusion problems using a lattice Monte!Carlo method [J].
Belova, I. V. ;
Murch, G. E. .
MULTISCALE KINETIC MODELLING OF MATERIALS, 2007, 129 :1-+
[8]   Lattice-Based Walks and the Monte Carlo Method for Addressing Mass, Thermal and Elasticity Problems [J].
Belova, I. V. ;
Murch, G. E. ;
Fiedler, T. ;
Oechsner, A. .
DIFFUSION IN SOLIDS AND LIQUIDS IV, 2009, 283-286 :13-23
[9]   COMPARISON OF FULLY RELATIVISTIC ENERGY-BANDS AND COHESIVE ENERGIES OF MOSI2 AND WSI2 [J].
BHATTACHARYYA, BK ;
BYLANDER, DM ;
KLEINMAN, L .
PHYSICAL REVIEW B, 1985, 32 (12) :7973-7978
[10]   APPLICATION OF TERNARY PHASE-DIAGRAMS TO THE DEVELOPMENT OF MOSI2-BASED MATERIALS [J].
BOETTINGER, WJ ;
PEREPEZKO, JH ;
FRANKWICZ, PS .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1992, 155 (1-2) :33-44