Investigation on magnetic properties of mechanically alloyed τ-MnAlC with Fe addition

被引:2
作者
Van Tang Nguyen [1 ,2 ]
Mazaleyrat, Frederic [3 ]
Calvayrac, Florent [4 ]
Quang Minh Ngo [1 ,2 ,5 ]
Randrianantoandro, Nirina [4 ]
机构
[1] Univ Sci & Technol Hanoi, Vietnam Acad Sci & Technol, 18 Hoang Quoc Viet, Hanoi, Vietnam
[2] Grad Univ Sci & Technol, Vietnam Acad Sci & Technol, 18 Hoang Quoc Viet, Hanoi, Vietnam
[3] Univ Paris Saclay, ENS Paris Saclay, CNRS, SATIE, 4 Ave Sci, F-91190 Gif Sur Yvette, France
[4] Le Mans Univ, Inst Mol & Mate Riaux Mans, UMR CNRS 6283, Ave Olivier Messiaen, F-72085 Le Mans 9, France
[5] Vietnam Acad Sci & Technol, Inst Mat Sci, 18 Hoang Quoc Viet, Hanoi, Vietnam
关键词
Mechanical alloying; Thermal Stability; Magnetic properties; MnFeAlC alloy; PERMANENT-MAGNETS; PHASE; MN;
D O I
10.1016/j.jmmm.2021.168892
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
The influence of Fe addition on thermal stability, crystallography, and magnetic properties of tau-Mn51Al47C2 was investigated. Alloys with composition Mn51-xFexAl47C2 (x = 0, 0.5, 1, 2, and 4) were synthesized by mechanical alloying method. High purity of tau-Mn(Fe)AlC up to 98% could be obtained after 10 h of milling, then annealed at 1050 degrees C for 1 h, and followed by an aging process at appropriate temperatures from 515 to 540 degrees C for 50 min. It was found that the thermal stability of both epsilon and tau phases was enhanced by the addition of Fe up to 4 at.% into MnAlC alloy through a shifting of epsilon-to-tau transformation temperature to high temperature region and a reduction in c/a ratio of Fe doped tau-MnAlC compared to iron free r-MnAlC. While the magnetization and Curie temperature of Fe doped tau-MnAlC showed a reduction compared to iron free tau-Mn51Al47C2, coercivity seems not to be significantly affected. Ab initio calculation showed a lower magnetic moment of Fe (mu(Fe) = 1.77 mu(B)) compared to Mn (mu(Mn)(_average) = 2.36 mu(B)) in tau-Mn(Fe)AlC when Fe substituted Mn position at la site.
引用
收藏
页数:8
相关论文
共 27 条
[1]   Permanent magnets: Plugging the gap [J].
Coey, J. M. D. .
SCRIPTA MATERIALIA, 2012, 67 (06) :524-529
[2]  
Coey JMD, 2009, Magnetism and magnetic materials, DOI DOI 10.1017/CBO9780511845000
[3]  
Cullity B D., 2011, Introduction to Magnetic Materials, DOI 10.1002/9780470386323
[4]   The HighScore suite [J].
Degen, Thomas ;
Sadki, Mustapha ;
Bron, Egbert ;
Konig, Uwe ;
Nenert, Gwilherm .
POWDER DIFFRACTION, 2014, 29 :S13-S18
[5]   Enhanced thermal stability of the τ-phase in MnAl-C alloys with Ni additions [J].
Feng, Le ;
Nielsch, Kornelius ;
Woodcock, Thomas George .
JOURNAL OF ALLOYS AND COMPOUNDS, 2021, 871
[6]   Growth of L10-ordered crystal in FePt and FePd thin films on MgO(001) substrate [J].
Futamoto, Masaaki ;
Nakamura, Masahiro ;
Ohtake, Mitsuru ;
Inaba, Nobuyuki ;
Shimotsu, Teruho .
AIP ADVANCES, 2016, 6 (08)
[7]  
Geng Y., 2014, MICROSTRUCTURE MAGNE
[8]  
Hopkinson J., 1889, Philosophical Transactions of the Royal Society of London, V180, P443, DOI [10.1098/rsta.1889.0014, DOI 10.1098/RSTA.1889.0014]
[9]   The Influence of Cu-Additions on the Microstructure, Mechanical and Magnetic Properties of MnAl-C Alloys [J].
Juerries, Florian ;
Freudenberger, Jens ;
Nielsch, Kornelius ;
Woodcock, Thomas George .
SCIENTIFIC REPORTS, 2020, 10 (01)
[10]   NEW MATERIAL FOR PERMANENT MAGNETS ON A BASE OF MN AND AL [J].
KOCH, AJJ ;
HOKKELING, P ;
VANDERSTEEG, MG ;
DEVOS, KJ .
JOURNAL OF APPLIED PHYSICS, 1960, 31 (05) :S75-S77